Owner's Manual for Honeywell models including: 5530M Series, Vista 20SE 5530M Series Cellular Communicators and Programming the Panel, Vista 20SE 5530M Series Panel, Cellular Communicators and Programming the Panel, Cellular Communicators Panel, Programming Panel, Programming, Panel, Cellular Communicators, Communicators
Product ation - Uplink Security Solutions
Honeywell Vista 20SE Wiring Uplink's 5530M Series Cellular Communicators and Programming the Panel CAUTION: · It is advised that an experienced alarm installer programs the panel as further programming may be required to ensure proper performance and use of the full functionality. · Do not route any wiring over circuit board. · Full panel testing, and signal confirmation, must be completed by the installer. NEW FEATURE: For 5530M Communicators, the status of the panel can be retrieved not only from the status PGM but now also from the Open/Close reports from the dialler. IMPORTANT NOTE: The Open/Close reporting needs to be enabled during the initial pairing procedure. Wiring the 5530M communicators to Honeywell Vista 20SE 1 of 2 Wiring and Programming Uplink Communicators to Honeywell Vista 20SE Programming the Honeywell Vista 20SE Alarm Panel via the Keypad Enable Contact ID reporting: Keypad Display DISARMED Installer Code Pri. Phone Field? Pri SubId Sec SubId Phone Sys Field? Rep Form Pri/Sec Field? Open Rpt Field? Awy/Sty Rp Field? Telco Monitor #Rpt/Arm Keypad Entry 4112800 *41 123456* *43 1234 *47 1 *48 7* *65 1* *66 1, 1* *92 0* *99 Action Description To enter programming menu To start configuring primary phone number Enter phone number value and press * to save and go back To start configuring "Part. 1 Primary Subs. Acct. No." Enter account number value To enter "Phone system select" menu To select "Tone Dial" and go back To enter "Report format" menu To select "Ademco Contact ID" for primary phone number To go to "Open report code" setup To enable reporting for "Open" event To go to "Arm Away/Stay Report Code" menu To enable reporting for "Away/Stay" events To go to "TLM" menu To disable TLM and save To exit programming mode 2 of 2Microsoft Word for Microsoft 365