MERCUSYS 4G LTE Router Quick Installation Guide

Hardware Connection

Follow these steps to connect the hardware:

1. Insert the Nano SIM card into the slot until you hear a click.
2. Connect the power adapter to the router.
3. Wait until the Power LED turns on. Your router is connected to the internet successfully.

Note: If the LED does not turn on (indicating no internet connection), refer to FAQ-2.

Enjoy the Internet: Connect your device to the router (wired or wireless). The default wireless network name (SSID) and password are printed on the label at the bottom of the router.

Customize the Router

1. Make sure your computer is connected to the router (wired or wireless).
2. Launch a web browser and type http://mwlogin.net. Create a password for future logins.
3. Follow the Quick Setup instructions to complete the initial configuration.

Note: The router can also be used (or configured) in Wireless Router Mode for DSL/Cable connections. For more information, please refer to the user guide at https://www.mercusys.com/support/.

FAQ (Frequently Asked Questions)

1. What should I do if I cannot access the web management page?

• Reboot your router and try again.
• If the computer is set to a static IP address, change its settings to obtain an IP address automatically.
• Make sure http://mwlogin.net is correctly entered in the web browser.
• Use another web browser and try again.
• Disable and then enable the active network adapter and try again.

2. What should I do if I cannot access the internet?

• Verify that your SIM card is an LTE or WCDMA card.
• Verify that your SIM card is in your ISP's service area.
• Verify that your SIM card has sufficient credit.
• Log in to the router's web management page, and check the following:
1. Go to Advanced > Network > PIN Management to verify if PIN is required. If it is, enter the correct PIN provided by your ISP.
2. Go to Advanced > Network > Internet to verify the parameters provided by your ISP are correctly entered. If they are incorrect, create a profile with the correct parameters, then select the new profile from the Profile Name list.
3. Go to Advanced > Network > Data Settings to verify if the used data exceeds the allowance. If it does, click Correct and set the used data to 0 (zero), or disable Data Limit.
4. Go to Advanced > Network > Internet to verify that Mobile Data is enabled. If it is not, enable it to access the internet.
5. Confirm with your ISP if you are in a roaming service area. If you are, go to Advanced > Network > Internet to enable Data Roaming.

3. How do I restore the router to its factory default settings?

• With the router powered on, press and hold the WPS/RESET button on the rear panel until the Power LED starts blinking, then release the button.
• Log in to the router's web management page, and go to Advanced > System Tools > Backup & Restore to reset the router.

4. What should I do if I forget my wireless network password?

• The default wireless password is printed on the product label of the router.
• Connect a computer directly to the router via an Ethernet cable. Log in to the router's web management page and go to Basic > Wireless to retrieve or reset your wireless password.