Cobra SC 200 Dash Cam Quick Start Guide

SC 200 Features

Key Features: QHD, GPS, 40° Wide Angle Lens

Components:

• Adhesive Mount
• GPS Mount
• USB Power Input
• Front View Camera Lens
• 3" LCD Screen
• Reset Button
• Micro USB Port (press and hold for power)
• Power Button
• Event/Emergency Recording Button
• Video Input Port for Flex Cam
• MicroSD Card Slot

Included Accessories:

• 8GB MicroSD Card
• Adhesive Mount and GPS Mount
• Vehicle Charger
• Micro USB Data Cable
• Quick Start Guide

Button Functions (Recording Stopped)

• Access Menu: Navigate to the dash cam settings menu.
• Voice Commands: The SC200 responds to voice commands. Try saying:
  • "Record Video" - Starts loop recording.
  • "Take a Photo" - Takes a snapshot and saves it to the Photo folder.
  • "Lock Video" - Locks the current clip against overwriting.
  • "Turn on Screen" - Activates the LCD screen.
  • "Turn off Screen" - Deactivates the LCD screen.

Button Functions (During Recording)

• Event/Emergency Recording Button: When pressed, the camera records the current clip against overwriting. If not recording, it starts emergency recording, locks the first video, and tags it as a favorite.
• Power Button: Activates/deactivates the microphone. The icon on the button indicates the action to be taken when pressed, not the current setting. The current setting is displayed in the status bar at the top of the screen.
• Take a Photo Button: Takes a snapshot of the front and/or rear view and saves it to the "Photos" folder.

Attaching Additional Flex View Cameras

For Cabin View: Connect the cabin camera to the SC 200's video input port.

For a View Behind You:

1. Connect the extension cable to the Dash Cam's video input port.
2. Connect the extension cable to the rear camera.
3. Mount the rear camera to the vehicle's rear windshield. Warning: Please position the camera on the rear windshield so that it faces outwards from the vehicle as indicated.

* Additional Flex View cameras sold separately.

Installation Steps

1. Attach the GPS mount and remove the protective film from the mount and the front lens.
2. Connect the assembly to the camera using the port on the side of the GPS mount.
3. Mount the camera to the windshield.
4. Connect the vehicle charger to the 12V power source.

FCC Information

FCC ID: BBOSC200, IC: 906A-SC200. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC NOTE: Modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.

Cobra® and the snake design are registered trademarks of Cobra Electronics Corporation, USA. Cobra Electronics Corporation™ is a trademark of Cobra Electronics Corporation, USA. Other trademarks and trade names are those of their respective owners.

©2020 Cobra Electronics Corporation

Scan QR Code for More Languages

Scan the QR code to access the guide in additional languages.