Costway Air Cooler EP24829 User Manual
Model: EP24829 / DC2002
Important Safeguards
READ ALL INSTRUCTIONS BEFORE USING
WARNING: To reduce the risk of fire, electric shock, or injury to person:
- Read all instructions before using. The product is for household use only.
- Before first use, please check that the voltage you use is in accordance with the product nameplate requirements.
- Always turn the product to the OFF position and unplug it from the electrical outlet when not in use.
- Extreme caution is necessary when the appliance is used by or near children, invalids or elderly person.
- Do not run cord under carpeting and do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic area and where it will not be tripped over.
- Please check the power cord and plug for breakage before using it.
- Do not operate the appliance with a damaged cord or plug, or after the unit malfunctions, has been dropped, or damaged in any manner.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person to avoid a hazard.
- Use the appliance in a well-ventilated area. While using, distance of no less than 4"(20cm) should be kept away from wall or corner to ensure the air intakes or exhaust openings should not be blocked unexpectedly. The unit must not be located directly below or besides a curtain or the likes.
- Use the appliance on flat, dry floor only.
- Do not use in high temperature, humidity, dusty or volatile places such as acid-base oil.
- Do not twist or pull the power cord to avoid bad contact.
- Do not place heavy objects on the machine to prevent pressure breakdown from causing trouble.
- Make sure the appliance is disconnected from the power supply when the power is cut off or moving.
- Do not place machine directly under the power outlet.
- When the whole machine is running, blocking duct and rear shell intake are not allowed. Don't use wire to plug into the passageway to prevent electric shock.
- During the automatic oscillation process, do not change the orientation with the hand to avoid damaging the shaking structure.
- Turn off the power supply before pulling out the plug. Do not pull the power cord. Pull out the power plug, otherwise it will lead to short circuit, fire and electric shock.
- Do not use wet hand to pull out the power plug, there is a danger of electric shock and induction.
- When leaving the room for a long time, please turn off the machine and unplug the plug.
- Do not use in places where curtains are easy to suck in. Avoid obstacles and unstable places around you.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Technical Specifications
Model No | EP24829/ DC2002 |
Voltage | 120V AC |
Frequency | 60Hz |
Rated Power | 45W |
Water Tank Capacity | 0.66 Gallon |
Water Consumption | 0.05Gallon/h |
Product Overview
Components:
- 1. Control panel
- 2. Air outlet
- 3. Water tank
- 4. Base
- 5. Remote
- 6. Ice box *4
- 7. Stopper
Assembly Instructions:
1. Take out the base components, then align the matching holes, and assemble the two bases into a circular base.
2. Turn the base upside down, assemble the base assembly in the previous step to the main body, and then fix it with the 4 screws.
Diagram Description: The product overview shows the main unit with numbered parts. A separate diagram illustrates the base assembly process, showing the base components, main body, and screws.
Instructions for Use
Control Panel Functions:
- 1. ON/OFF button [▶️]: Press to start or stop the fan.
- 2. SPEED button [?]: Press to set the desired fan speed (Low - 1, Medium - 2, or High - 3).
- 3. TIMER button [⏱️]: Set the desired shutdown time (1-9 hours) or an automatic switch-on time.
- 4. OSC button [?]: Press to activate or deactivate side-to-side oscillation.
- 5. COOLING button [❄️]: Press to activate cooling mode if water and ice boxes are added. Press again to stop.
Note: The fan will turn off after 5 minutes of high-speed delay operation to dry the wet curtain when in cooling mode.
Caution: Do not start the cool function without water in the tank, as this can damage the water pump. DO NOT add water when the power is on.
How to Add Water:
Pull out the back cover and add clean water to the water tank.
Warning: Water level must not exceed the "MAX" mark or be lower than the "MIN" mark.
Warning: Be careful of the sharp edge of the water tank!
How to Use Ice Box:
Place the included ice boxes (4 total) in your freezer for 1-2 hours. Then, put the frozen ice boxes into the water tank.
Caution: Do not place ice boxes into a full water tank. Ice boxes are permanently sealed; do not open them or attempt to put the cooling gel directly into the water tank, as this can damage the water pump.
Additional Modes:
- 6. SLEEPING button [?]: Activates sleeping mode with varying wind speeds over time (High-Medium-Low for 30 mins, Medium-Low for 60 mins, or continuous Low).
- 7. SCREEN OFF button [?]: Turns the display on or off. The screen automatically turns off after 3 minutes of inactivity.
Remote Control: All functions can be controlled using the remote control by pressing the corresponding buttons.
Battery Installation (Remote Control)
1. Pull out the remote control battery holder according to the assembly drawing on the back of the remote control.
2. Insert the battery into the holder, observing the positive (+) and negative (-) poles.
3. Reinstall the battery holder with the battery into the remote control.
Diagram Description: Three steps illustrate battery installation for the remote control, showing pulling out the holder, inserting the battery, and reinserting the holder.
Troubleshooting
Trouble | Possible Cause | Corrective Action |
---|---|---|
Fan fails to operate | 1. Unplugged or poorly contacted power cord. 2. Failure to press the switch. 3. Machine damaged. |
1. Plug in the power cord. 2. Press the switch. 3. Delivery to Maintenance Point for Maintenance. |
Unable to shutdown | Machine damaged. | Delivery to Maintenance Point for Maintenance. |
Abnormal sound | 1. Wind wheel loosening. 2. Motor breakdown. |
1. Delivery to Maintenance Point for Maintenance. 2. Delivery to Maintenance Point for Maintenance. |
Cannot change the direction of the wind | Breakdown of wind guide synchronous motor. | Delivery to Maintenance Point for Maintenance. |
Maintenance and Storage
Cut off the power supply before maintenance.
- If the body has oil pollution, clean it to avoid discoloration and damage.
- Do not rinse directly with water.
- Do not wipe with diluent, toluene, acid lotion, oil, etc., to avoid discoloration or deterioration.
- To clean the air filter: Unplug the power cord, unscrew and disassemble the air filter. Clean it using clean water and a soft brush.
- To clean the wet curtain paper: Remove the wet curtain paper, clean it using clean water and a soft brush, and reinstall it properly. Ensure no leakage.
- Before storage, remove all water from the water tank by opening the bottom stopper. For long-term storage, pack parts in the original package and store in a dry place.
Global Presence
Costway offers an easy shopping experience, good products, and efficient service worldwide. The manual includes marketing text in multiple languages (English, German, French, Spanish, Italian, Polish) and lists international offices in the US (Fontana), UK (Ipswich), Germany (Hamburg), and France (Neuville en Ferrain).