Britax ONE4LIFE™ CLICKTIGHT® Anti-Rebound Bar Instructions

Anti-Rebound Bar

• Anti-Rebound Bar
• Anti-Rebound Bar Cover
• No Tools Required

IMPORTANT: The anti-rebound bar MUST be used rear-facing. DO NOT use forward-facing.

Installing the Anti-Rebound Bar

1. Open the CLICKTIGHT door. Squeeze the CLICKTIGHT release buttons underneath the front cover flap and lift to open.

   Diagram Description (Fig. 1): Illustration showing the CLICKTIGHT door being opened by pressing release buttons and lifting the cover.

2. Insert the anti-rebound bar into the two openings at the front of the seat.

   Diagram Description (Fig. 2): Illustration depicting the anti-rebound bar being inserted into the designated openings at the front of the car seat.

3. Attach elastic bands from the cover to the hooks on the shell.

   Diagram Description (Fig. 3): Illustration showing elastic bands from the cover being secured to hooks on the car seat shell.

4. Pull the anti-rebound bar to ensure it is properly set.

Removing the Anti-Rebound Bar

1. Open the CLICKTIGHT door.

2. Unhook elastic bands from the front of the seat.

   Diagram Description (Fig. 4): Illustration showing elastic bands being unhooked from the front of the car seat.

3. Push the inner red button. Pull the anti-rebound bar away on one side. Repeat on the other side.

   Diagram Description (Fig. 5): Illustration showing the anti-rebound bar being removed. A close-up view highlights a red button labeled "[PUSH]" that needs to be pressed to detach the bar.

Cleaning

Sponge clean using warm water and mild soap. Towel dry.