JEDVER SMART LED DRIVER

Dimensions

The JEDVER SMART LED DRIVER is available in different models with varying dimensions and power outputs.

Driver Specifications

Input Voltage: 12/24V DC

Model 1:

Power: 20W

Dimensions: Length 112mm, Height 75mm

Visual representation shows a rectangular unit with dimensions marked.

Model 2:

Power: 40W

Dimensions: Length 160mm, Height 75mm

Visual representation shows a rectangular unit with dimensions marked.

Model 3:

Power: 60/90W

Dimensions: Length 185mm, Height 75mm

Visual representation shows a rectangular unit with dimensions marked. A side view indicates a width of 17mm and a connection interface with 8 pins.

Connection

Follow these steps to connect the JEDVER SMART LED DRIVER:

1. Step 1: Connect the driver to the control unit. A separate connector piece is shown being inserted into the driver unit. A detail indicates to 'Press and hold' a button on the driver during connection.

   [Diagram shows a driver unit and a separate connector, with an arrow indicating insertion and a text bubble saying "Press and hold".]

2. Step 2: Connect the LED strip wires to the driver. The wires are labeled [LED].

   [Diagram shows wires labeled "LED" being connected to the driver unit.]

3. Step 3: Connect the power cable to the driver unit using a suitable connector.

   [Diagram shows a connector being plugged into the driver unit.]

4. Step 4: Connect the driver to the mains power supply. The driver supports 100-240V AC. A power plug is shown connecting to a wall socket. A warning symbol indicates potential hazard.

   [Diagram shows a power plug with a 100-240V AC label and a warning symbol ([warning]), connecting to a wall socket.]