Installation Guide for AVIANCE lighting models including: 46923, 46924, 46925, 46033, 46034, 46035, 46144, 46145, HD86333 Adalone 4-Light Black Pendant, Adalone 4-Light Black Pendant, 4-Light Black Pendant, Black Pendant, Pendant
1 день назад — ASSEMBLING THE FIXTURE (Fig.1). 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. FIG.1 Junction Box (Not included) HD86333 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. Fixture Ground Wire Mounting plate ASSEMBLING THE FIXTURE (Fig.1) Ground Mounting screw 1. Shut off the power at the circuit breaker box. Remove old fixture and Wire all hardware from Junction Box. The junction box is not included. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation. A 3. Determine the desired hanging height. Slide the electrical wires through the shade(F)/ thin nut(E)/tubes(D)/(C)/(B) and canopy(A). 4. Raise the center hole of shade(F) to top thread of lamp holder(G), lock it securely with the thin nut(E). Raise the tube(D)/(C)/(B) and canopy(A) to the pipe thread in order, then by turning it clockwise until tight. 5. Thread the two mounting screws into the pre-drilled holes in the D0.5"*L6'' 1PC D0.5"*L12'' 1PC D0.5"*L18'' 1PC Column nut B C Mounting plate spaced the same distance apart as the holes in the canopy (A). Attach the Mounting plate to the Junction Box with the D two Junction Box screws as shown. The side of the Mounting plate marked "GND" must face to out. 6. While holding the fixture lamp towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are E F secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the G fixture ground wire to it. Otherwise connect fixture's ground wire directly to the Mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box. FIG.2 FIXTURE WIRES Black or FIXTURE WIRES White or FIXTURE WIRES Bare 7. Raise the canopy (A) on to the Junction box, aligning screws on mounting plate with mounting holes in canopy and lock it securely with the column nuts. 8. Install the light bulbs(Not included) in accordance with the fixture specifications. NOTE: DO NOT EXCEED THE SPECIFIED Smooth Ribbed HOUSE WIRES Black(Hot) HOUSE WIRES White (Neutral) Copper (Ground) HOUSE WIRES Green or Bare Copper(Ground) WATTAGE! Thank you for purchasing an AVIANCE product. Your installation is now complete. Return power to the junction box Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net and test the fixture. ©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC. DOC202503HD67547Acrobat Distiller 9.3.2 (Windows)