User Guide for Holybro models including: PM02D, Power Module, PM02D Power Module, PM02D Pixhawk 5X Power Module, Pixhawk 5X Power Module
PM02D provides regulated power supply for your Pixhawk 5X from the battery, as well as current consumption and battery voltage measurements, all through a ...
P a g e | 1 www.holybro.com PM02D Power Module PM02D provides regulated power supply for your Pixhawk 5X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin
File Info : application/pdf, 2 Pages, 668.49KB
DocumentDocumentPM02D Power Module PM02D provides regulated power supply for your Pixhawk® 5X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 6S. The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection. This Power Module is designed to power Pixhawk® 5X and its accessories (GPS, radio, receiver). It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact. Spec Max input voltage: 36V Rated current: 60A Max current: 120A (<60S) Max current sensing: 164A Supports up to 6S battery Voltage and current monitor with I2C compatible interface Switching regulator outputs 5.2V and 3A max Weight: 20g Package Includes PM02D Power Module 6pin 2.00mm pitch cable P a ge |1 www.holybro.com Current Rating: The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. The specifications and models are as follows: Plug Specification Wire Size Rated current: (4 hours, temperature rise <60 Deg C) Burst Current: (1 minute, temperature rise <60 Deg C) XT60 12 AWG 30A 60A XT90 10 AWG 45A 90A XT120 8 AWG 60A 120A PIN MAP: Note: PM02D does not require users to set the voltage divider and the current divider ratio. With the default setting parameters, the voltage and current measurement accuracy can be better than 5%. Holybro is a registered trademark of Holybro, registered in the U.S. and other countries. ©Copyright 2018 Holybro. All Rights Reserved. P a ge |2 www.holybro.comMicrosoft? Word 2010