User Manual for Shenzhen Sunveytech models including: MY-CX77615, MYCX77615, 2AQNR-MY-CX77615, 2AQNRMYCX77615, MY-SNR-CX77 Digital Wireless Backup Camera Systems, MY-SNR-CX77, Digital Wireless Backup Camera Systems
SHENZHEN SUNVEYTECH CO.,LTD MY-CX77615 2AQNR-MY-CX77615 2AQNRMYCX77615 my cx77615
File Info : application/pdf, 11 Pages, 621.89KB
DocumentDocumentDIGITAL WIRELESS BACKUP CAMERA SYSTEMS
User Manual / Installation Instructions
VEHICLE SAFETY SOLUTIONS Before installation please read the manual
What's in the Box?
01
02
03
04
05
06
07
08
09
10
11
NOTE: The contents included may be different based on the kit you purchased. Please take the actual product as standard.
01. 7inch IPS Monitor 02. Camera 03. U-shaped bracket 04. Butterfly bracket
05. Car Charger 06. Sunshade 07. User Manual 08. Power cable
09. Antenna 10. Accessories 11. Installation tool
Introduction
Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer's warranty.
Thank you very much for purchasing a Rear View Backup Camera System. With this manual you will be able to properly install and operate the unit. The Backup Camera System is intended to be installed as a supplement aid to your standard rear view mirror that already exists in your vehicle. The Backup Camera System should not be used as a substitute for the standard rear view mirror or for any other mirror that exists in your vehicle. In some jurisdictions, it is unlawful for a person to drive a motor vehicle equipped with a TV viewer or screen located forward of the back of the driver's seat or in any location that is visible, directly or indirectly, to the driver while operating the vehicle.
Monitor Operation
Button Function Use this button to turn the monitor On and Off 1) Brightness "-" 2) Enter the menu select left 3) "-" 1) Brightness "+" 2) Enter the menu select right 3) "+" Switch channel 1) Menu 2) Return to previous level 1) Confirm key 2) Car ruler 3) Long press "SEL" to call up V/H/W
On the back of the monitor, you can insert an TF card Open the SD card slot on the monitor back with a screwdriver,insert SD card It is recommended to use high-speed TF card of class 10 or above.(Less than 128G) Plug in the card to start recording("SEL" to turn on/off recording) Recording: REC
Sector bracket installation method
Installation Diagram
Monitor Installation Choose a monitor location in your vehicle that does not block your view and complies with local laws for safe driving. Do not place in an area where it might interfere with driving.
Camera Installation Suitable Installation Position
Connection method
Car charger connect to wireless receiver in the monitor
1
"+"ACC/Fuse/radio
"-"
2
"+" Taillight "-" Ground
Note: Of connecting power directly to battery, the cameras always ON and therefore candrain battery. Therefore it is recommended to connect power to an ignition switched accessory power source.
Pairing the Camera and Monitor
NO SIGNAL
1. Select the channel to be pairing
2. Enter the menu and select pairing
3. Start pairing
4. Waiting for matching and drawing successfully
NOTE: when you need pairing,please confirm the circuit is properly connected and powered.If you need to pairing multiple cameras, please switch to the corresponding channel.
Specifications
Power Supply Wireless Frequency 2.4G Wireless network range Wireless Range Delaying Time Operating temperature
CAMERA Image Sensor Waterproof Rating View Angle Camera Pixel
DC12 to 36V 2.4 GHz 2406-2478MHz 300m(open area) <200ms -20°C ~ 80°C
1/3 inch IP68K 127°[H] 170°[D] 1000TVL
LCD Size Resolution Contrast Brightness Response Time Power Consumption
MONITOR
7 inch IPS 1024(H) x 600(V) 500:1 500cd/ 25ms <500mA
Troubleshooting
Problem Monitor Won't turn on Camera and Monitor won't pair
Weak Signal
Night Vision is poor Dark Picture
Solution Check the cigarette lighter has 12-36V DC Output Check the fuse in the Cigarette socket adapter Check if the camera is receiving power Make sure to follow the instructions to operate the Pairing
Check if the camera and monitor antennas are installed Distance between camera and monitor is too great. Reduce distance between camera and monitor Large dense objects could be obscuring the signal. If possible, move the objects Interference from overhear power lines may be affecting the signal Try unpairing and pairing
The night sensor on the camera may be dirty or obstructed Ensure the camera is installed at least 2 inches away from rear lights Check whether brightness and contrast are adjusted correctly
&t^ZZZZZZZZZZZZZd ZZZZZWZ&ZdZZZZZ ZdZZZZ ZZZZ,ZZZZZ/Z ZZZZZZZZZZZZ ZZZZZ ZZZZ /Z ZZZZZZZ ZZZdsZ
dZZ&ZKZZZZZZZdZ ZZ
Acrobat Distiller 11.0 (Windows)