Geode GNS3 Receiver Quick Start Guide

Product Overview

The Geode GNS3 Receiver is a versatile GNSS device designed for accurate positioning. This guide provides essential information for getting started with your device.

Hardware Features

A) MCX ANTENNA PORT: Connect your GNSS antenna here.

B) USB TYPE-C PORT: Used for charging and data transfer.

C) LED FUNCTION: Indicates the status of the receiver.

LED Status	GPS/DGPS Fix	Bluetooth	Charging	Power
LIGHT OFF	No 3D GNSS position	No connection	No external power applied	Unit off
FLASHING LIGHT	3D GNSS position	N/A	Slow = charging Fast = power fault	Battery low
SOLID LIGHT	Corrected position	Connected	Fully charged	Powered on

USB Cables

USB Type-C to Type-C: Recommended for primary charging, especially when the device is powered ON and charging simultaneously.
USB 3.0 A to Type-C: Legacy cable for charging when the receiver is powered OFF.

Hardware Reset

The Geode GNS3 Receiver has a hardware reset function. To perform a reset, press and hold the power button:

Soft Reset: Press and hold for 5 seconds. Release when the green LED flashes slowly. This resets all messages to the default state and clears the almanac.
Factory Reset: Press and hold for 15 seconds. Release when the green LED flashes fast. This resets all messages to the default state, clears the almanac, ephemeris, and real-time clock.

Charging and Software

CHARGE BATTERY: Allow four to six hours for a full charge before first use.

Geode Connect™ Software: Download Geode Connect™ for iPhone®, iPad®, Android™, and Windows PC from the App Store®, Google Play, or at www.junipersys.com/support/geode/downloads.

User Manual: Download the complete Geode User Manual at www.junipersys.com/support/geode/documentation.

Trademarks and Compatibility

Geode and Geode Connect are trademarks of Juniper Systems, Inc. iPhone and iPad are trademarks of Apple Inc. App Store is a service mark of Apple Inc. Android, Google Play, and the Google Play logo are trademarks of Google LLC. Windows is a trademark of Microsoft Corporation. Bluetooth is a trademark of Bluetooth SIG, Inc.

The "Made for Apple" badge indicates that an accessory has been designed to connect specifically to the Apple product(s) identified in the badge and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.