Installation Guide for Home Depot models including: Toilet Bidet, Bidet
il y a 22 heures — Check if the bidet, stainless steel pipe, clips, seals, screws, and manual are complete. Turn off the toilet's water inlet valve and prepare a wrench and a.
Check if the bidet, stainless steel pipe, clips, seals, screws, and manual are complete. Turn off the toilet's water inlet valve and prepare a wrench and a.
Installation Guide for the Toilet Bidet Step 1: Preparation Check if the bidet, stainless steel pipe, clips, seals, screws, and manual are complete. Turn off the toilet's water inlet valve and prepare a wrench and a cloth. Step 2: Remove Old Parts Use the wrench to disconnect the toilet tank's inlet pipe. Clean the interface thoroughly to remove dirt and water. Step 3: Install the Bidet Attach a seal to the bidet's inlet, then connect the pipe and tighten with a wrench. Fix the bidet to the toilet side using the provided clips and screws. Step 4: Connect to Water Link the other end of the pipe to the tank, ensuring a tight fit. Open the water valve and check for leaks. Tighten any loose connections if needed. Step 5: Test the Bidet Adjust the water pressure and switch between rear and front wash modes via the knob. Make sure the water flow is steady and both modes work properly.WPS 文字