Instructions for Starkrimson models including: Duo Trio Preorder, Trio Preorder, Preorder
Starkrimson Duo/Trio Preorder - 150W GaN Audio Power Amplifier
Rev 1.1 Starkrimson® Duo/Trio Instructions NOTES: · Due to the bridged amplifier design, all speaker terminals are hot when the amplifier is on. o Warning High Voltage o Do not connect any of the outputs to ground or earth. o When connecting to subwoofer's high-level input(s), double check this is supported. Contact us if not sure. · Do not power up or operate the amplifier without speakers connected to all channels. o For the Trio configuration - if you need to run the amplifier without a center channel install the provided resistor as a dummy load on that channel and leave the input disconnected. When the center channel is in use this resistor must be removed. Contact us if additional guidance is needed. · No user-serviceable parts tampering with the amplifier will void the warranty. To turn the amp on: · Connect speakers to all channels · Connect Inputs (XLR) on all channels (see above if the center channel is not used on a Trio). · Plug in the power cord (the switch must be in the off position) · Turn the amplifier on by flipping the switch to the on position. To turn the amp off: · Turn it off by flipping the switch to the off position. · Wait at least 15 seconds before removing any connections Improper powerup or power down of the amplifier may cause damage and this damage will not be covered under the warranty. How do you like them apples?Microsoft Word 2019