WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
This document provides essential installation instructions for The Great Outdoors 73330-66A light fixture. Please read and save these instructions for future reference.
Mounting the Fixture
- Ensure power is off at the circuit breaker before starting. Remove the old fixture.
- Unpack all parts carefully and lay them out in a clear area.
- Install glass panels onto the fixture body and secure them.
- Position the mounting plate on the wall, mark holes, pre-drill, and insert drywall anchors if needed.
- Attach the mounting plate to the junction box using the provided mounting screws, ensuring the "GND" side faces out.
- Secure the mounting plate with wood screws into the anchors.
Connecting the Wires
- Connect the fixture wires to the house wires according to the diagram, ensuring all connectors are secure.
- Connect the ground wire to the house ground wire or directly to the mounting plate.
- Tuck wire connectors neatly into the junction box.
Completing the Installation
- Align the fixture body onto the mounting plate and secure it with washers and screws.
- To prevent moisture ingress, apply clear caulking around the fixture back-plate where it meets the wall, leaving a small gap at the bottom for moisture escape.
- Place candle covers over the sockets.
- Install bulbs (up to 60W or equivalent CFL/LED, not included), adhering to fixture specifications. Do not exceed the specified wattage.
- Close and latch the fixture door.
Once installation is complete, restore power and test the fixture. Note that illustrations are for guidance and may not perfectly match the purchased fixture.
