User Manual for Lucid Audio models including: RRD8400SB, 2AU6S-RRD8400SB, 2AU6SRRD8400SB, BT HEARMUFFS, HearMuff Lucid Audio Bluetooth Headphone
LUCID AUDIO RRD8400SB Hearmuff Bluetooth 2AU6S-RRD8400SB 2AU6SRRD8400SB rrd8400sb
B l u e t o o t h Model:BT HEARMUFFS User Manual 1. Volume/Track Up 2. Power button 3. Volume/Track Down 4. USB Charging port 5. LED indicator Light 1 2 3 4 5 Task Button Press Turn on Center 3 Seconds Turn off Center 3 Seconds Bluetooth Pairing Center Hold for 6 Seconds Volume Up Top Short Press Volume Down Bottom Short Press Track Center Press 2 Forward Button Times Track Back Center Button Press 3 Times Fast How to use A. Charge: 1. Connect USB charging cable to the headphones and a USB source 2. LED light turns red when charging, and turns off when charged B. Pairing: 1. With headphones turned off press and hold the center button until the LED flashes a rapid blue light and you hear the words "pairing mode." 2. On your device, turn on the Bluetooth function, and set it to search for Bluetooth devices. 3. Select "BT Hearmuff" from the list of found devices 4. When paired, the LED flashes blue slowly. Note: During pairing, if the headphones are not connected to a device within 5 minutes, they automatically turn off. When successfully paired, your headphones automatically reconnect to the most recently paired device when switched on. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the followingtwo conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Information. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. HearMuff Bluetooth 0421 - REV A ISED Statement English: This device complies with Part 15 of the FCC Rules [and contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS standard(s)]. Operation is subject to the following two conditions: (1)this device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B). French: L'émetteur/récepteurexempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et DéveloppementéconomiqueCanada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. l'appareil numérique du ciem conforme canadien peut - 3 (b) / nmb - 3 (b). This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance. cet appareil est conforme à l'exemption des limites d'évaluation courante dans la section 2.5 du cnr - 102 et conformité avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des données canadiennes sur l'exposition aux champs rf et la conformité. This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. Cet équipement est conforme aux limites d'exposition aux rayonnements du Canada établies pour un environnement non contrôlé. RF Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be usedin portable exposurecondition without restriction. L'appareil a été évalué pour répondre aux exigences générales d'exposition aux radiofréquences. L'appareil peut être utilisé en condition d'exposition portable sans restriction. HearMuff Bluetooth 0421 - REV AAdobe Illustrator 25.2 (Macintosh) Adobe PDF library 15.00