TOOKO JUNIOR

1. Delivery Contents

• Vehicle (x1)
• Controller (x1)
• Accessories (x1)
• Instruction manual (x1)

2. Battery Installation

Ensure the power switch is in the "OFF" position before installing batteries.

Controller (Transmitter) Batteries:

? 2 x 1.5V "AA"/LR6/AM3 batteries (not included)

Vehicle Batteries:

? 3 x 1.5V "AG13"/LR44 batteries (included)

Note: Remove batteries from the toy when it is not being used for a long period of time.

3. Parts Identification

• FORWARD: Control forward movement.
• BACKWARD: Control backward movement.
• ON/OFF button: Powers the device on or off.
• Manual screwdrive: Tool for assembly.
• RC Mode Switch: Selects operating mode (Forward, OFF, Backward).

4. Part List

Total 21 parts included.

• 1. Chassis/Base
• 2. Front Part
• 3. Rear Part
• 4. Front Body Shell
• 5. Rear Body Shell
• 6. Wheels (x4)
• 7. Axles/Connectors (x2)
• 8. Controller (Transmitter)
• 9. Battery Cover (Vehicle)
• 10. Screws (x2)
• 11. Screwdriver

5. How to Build

Assembly requires an adult.

1. Step 5.1:

   Attach the front part (2) and rear part (3) to the chassis (1).

2. Step 5.2:

   Secure the front body shell (4) and rear body shell (5) onto the chassis.

3. Step 5.3:

   Insert axles/connectors (7) into the chassis, attach wheels (6) to the axles, and then attach the wheel assemblies to the chassis.

6. How to Play

1. Step 6.1: Slide the Mode switch to RC Mode.

   This allows the vehicle to respond to the controller.

2. Step 6.2: Switch on the transmitter.

   Ensure the transmitter is powered on to control the vehicle.

3. Step 6.3: Press to activate sound effect.

   Press the designated button on the controller to trigger sound effects.

Safety Information and Compliance

General Warnings

WARNING: Not suitable for children under 36 months. Contains small parts. Choking Hazard.

For ages 3+.

Safety Precautions

• Parents are advised to review operating instructions with children.
• Do not pick up the toy when it is moving.
• Keep hands, hair, and loose clothing away from moving parts when the toy is ON.
• Remove batteries from the toy when not in use.
• Do not operate the vehicle on public streets. Avoid hitting people, pets, or home furnishings.
• Assembly must be performed by an adult.

Battery Handling

• Dispose of used batteries immediately.
• Keep new and used batteries out of the reach of children.
• If batteries are suspected to have been ingested or placed inside a body part, contact a poison control center immediately.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries must be removed from the toy before charging and charged under adult supervision.
• Do not mix different types of batteries (e.g., alkaline, standard, rechargeable) or new and used batteries.
• Use only batteries of the same or equivalent type as recommended.
• Insert batteries with correct polarity (+ and -).
• Exhausted batteries must be removed from the toy.
• Supply terminals are not to be short-circuited.

Safety Circuit

During operation, the internal power can become high (e.g., during a 360° spin). A safety circuit will shut down the vehicle for approximately 1 minute to protect the electronic circuits. The car will not respond to signals during this period but will resume normal operation afterward. This is a safety feature, not a defect.

Care and Maintenance

• Always remove batteries from the toy when it is not being used for a long period.
• Wipe the toy gently with a clean damp cloth.
• Keep the toy away from direct sunlight and direct heat.
• Do not submerge the toy in water, as this can damage electronic components.
• Operating temperature: 5°C - 35°C.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device. If interference occurs, users are encouraged to try correcting it by reorienting the receiving antenna, increasing separation between equipment and receiver, or connecting the equipment to a different circuit. Consult a dealer or experienced technician for assistance.

WEEE (Waste Electrical and Electronic Equipment)

When this appliance is out of use, remove all batteries and dispose of them separately. Bring electrical appliances to local collecting points for waste electrical and electronic equipment. Other components can be disposed of in domestic refuse. The crossed-out dustbin symbol indicates that batteries must not be put in household waste. Batteries are harmful to health and the environment. Please help protect the environment. Dispose of batteries according to local battery recycling or disposal laws.

EU Declaration of Conformity

Silverlit Toys Manufactory Ltd declares that the radio equipment type SK17070 complies with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at: www.silverlit.com/a/certificate