AC WORKS® | Power Cords and Power Adapters for RVs, EVs, Welders – AC Connectors
User Manual for AC WORKS models including: AS1450R Range Generator 50 Amp, AS1450R, Range Generator 50 Amp, Generator 50 Amp, 50 Amp, Amp
AC WORKS [AS1450R] RV/Range/Generator 50 Amp NEMA 14-50R DIY Assembly – AC Connectors
File Info : application/pdf, 1 Pages, 389.05KB
DocumentDocumentQUESTIONS? Email, call or text our Customer Service Dept. Direct: (414) 434-2220 Text: (414) 323-3240 info@acconnectors.com NEMA 14-50 50 AMP RECEPTACLE ASSEMBLY 1. Remove 2.5" of the outer jacket and strip off 0.5" of the inner jacket on the green wire. 2. Cut the red and black wires to 3.125" and strip off 0.5" of the inner jackets. 3. Cut the white wire to 3.785" and strip off 0.5" of the inner jacket. 4. Before wiring, be sure to put the strain relief back on the cable. DO NOT re-aach the cable clamp yet. 5. Aach each wire to their proper terminal. The green should be last and is easiest to aach when it is going straight ahead into the ground prong. 6. The cable clamp now goes back into place. 7. Put the handle back into place. 8. Put the back cover into place. 9. Tighten screws. FIGURE 1 3.785" 3.125" 2.5" 3.125" 1/2"White (W) Black (Y or X) Green (G) Red (X or Y) When making connecons, make certain they are secure, properly insulated, and there are no stray wire strands outside the terminals. Tighten the terminal screws to 12-16 in-lbs torque. Tighten the cord clamp assembly screws to a maximum 10-12 in-lbs torque. Lastly ghten the assembly screws. (8)Put Handle Back QUESTIONS? Email, call or text our Customer Service Dept. Direct: (414) 434-2220 Text: (414) 323-3240 info@acconnectors.com NEMA 14-50 50 AMP RECEPTACLE ASSEMBLY 1. Remove 2.5" of the outer jacket and strip off 0.5" of the inner jacket on the green wire. 2. Cut the red and black wires to 3.125" and strip off 0.5" of the inner jackets. 3. Cut the white wire to 3.785" and strip off 0.5" of the inner jacket. 4. Before wiring, be sure to put the strain relief back on the cable. DO NOT re-aach the cable clamp yet. 5. Aach each wire to their proper terminal. The green should be last and is easiest to aach when it is going straight ahead into the ground prong. 6. The cable clamp now goes back into place. 7. Put the handle back into place. 8. Put the back cover into place. 9. Tighten screws. FIGURE 1 3.785" 3.125" 2.5" 3.125" 1/2"White (W) Black (Y or X) Green (G) Red (X or Y) When making connecons, make certain they are secure, properly insulated, and there are no stray wire strands outside the terminals. Tighten the terminal screws to 12-16 in-lbs torque. Tighten the cord clamp assembly screws to a maximum 10-12 in-lbs torque. Lastly ghten the assembly screws. (8)Put Handle Back (7)Rest on Curved Side (7)Rest on Curved Side (4)Strain Relief www.ACWORKS.com (4)Strain Relief www.ACWORKS.com