Instruction Manual for Shenzhen Jiabei Technology models including: IFW01, 2A2EY-IFW01, 2A2EYIFW01, IFW01 Wireless Charger With Night Light, Wireless Charger With Night Light
Shenzhen JiaBei Technology Co., Ltd. IFW01 IFW01 Wireless Charger with Night Light 2A2EY-IFW01 2A2EYIFW01 ifw01
IFW01 Wireless Charger With Night Light Its design is creative,simple and modern.And it can be used in these places,such as family,bedroom, office,hotel etc. It can be compatible with all mobile phones comply with QI standard. Also support fast wireless charging-charging power at 5W,7.5W,10W. 1.Touch Swith 2.Support Fast Wireless Charging 3.Night Light In Dark 1.Please use proper phone adaptor comply with QC protocol to charge this device(Check the picture as below) 4.Night light mode: touch to turn on the light. A.First touch, brightness is 100% B.Second touch, brightness is 50% C.Third touch, brightness is 10% D.Fourth touch,it will be turned off 1pc 100cm USB Cable 1pc User Manual 1pc Package Box 1.Please keep it far away from water or other liquid 2.Please turn it off if you want to clean it up 3.Working temperature should be -20~45 Thanks for choosing this phone wireless charger. In order to use it in a safe and convenient way, please read the manual carefully to ensure your better using experience. Night Light Mode 2.Indicator lights will flash between blue and white light, then white light is always on, which means it is used properly. 3.Charge your mobile phones in the power sensor area, when white light turns into blue light, then mobile phones receive the power charging signal, which means its power charging function is working good. After fully charged, the light will be white. Input Voltage: DC 5V 2.1A 9V 2A Power: 5W/7.5W/10W/15W Power Conversion Efficiency: 75% Charging Port: Type-C This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.Adobe PDF library 15.00