ITC Beach Table Installation

Option 1: Beach Table no hole

Model: TTC2200-XXC26262-00-SR

Install with ITC Sand Bar leg or ITC Cypress leg

1. Install Sand Bar leg:

   • Sand Bar can be used in sand, water, dirt, loose gravel.
   • Be sure Sand Bar is secure and post is up right.
2. Locate the table base on the bottom side of the table.
3. Align table base with leg post and firmly push on the top center of the table to fully seat the table to the leg post. Load evenly to avoid tipping.

Option 2: Beach Table with Umbrella hole

Model: TTC22HL XXC26262-00-SR

1. Follow steps above.
2. Once table is secured to the post, assemble Umbrella pole.
3. Insert Umbrella in pole through the hole in the table into the leg post.

To Remove Table Top

1. Grip table at 3 and 9 and pull straight up.
2. Table should release – if it is tight, twist table slightly while pulling up.
3. If it still sticks – depress the black button on the top of the leg post (Cypress leg option only).