Instructions for Winline models including: RF14K, RF14K Remote Control, Remote Control, Control
Shenzhen VSS Winline Electronics Co.,Ltd RF14K Remote Control 2BE8U-RF14K 2BE8URF14K rf14k
RF14K Remote Control by Shenzhen VSS Winline
Power on/off. Speed + Mode-(358 modes) Brightness Speed Remote control ID matching: Long press 5 seconds remote control one to one match (led strip green flash 3 times), again long press 5 seconds to cancel the match (led strip white flash 3 times). Single cycle play:At automatic playback mode,press the"Set" button once, then press the "lock"button to capture the current eect loop play. Short press to anto play 358 kinds of eects. Long press 5 seconds to enter the RGB colorful jump effect to facilitate led strip test. Mode+ (358 modes) Brightness+ To adjust the number of LED pixel points and the RGB order:Long press 5 seconds. to enter the setup menu and press SPEED+ and SPEED- to adjust the number of LED pixel points,and no less than 10 pixels. Press the B button to adjust the RGB sequence until the color sequence of the lights gets blue; Press the G button to adjust the RGB sequence until the color sequence of the lights gets green; Press the R button to adjust the RGB sequence until the color sequence of the lights gets red; last press setup button for save RGBW Static monochrome mode FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.Microsoft Word 2013