Hammer-On Flange Clip
The Hammer-On Flange Clip is designed for secure attachment to flanges. It is made from spring steel.
Specifications for Standard Flange Applications
| Part Number | Article Number | Flange Thickness [in] | Flange Thickness [mm] | Static Load Limit lbs [N] |
|---|---|---|---|---|
| 2H4* | 170010 | 3/32"–9/64" | 2-3 | 160 [712] |
| 4H24* | 170020 | 1/8"–1/4" | 3-8 | 200 [890] |
| 4H58* | 170030 | 5/16"–1/2" | 8-14 | 200 [890] |
| 4H912* | 170040 | 9/16"–3/4" | 14-20 | 200 [890] |
| 4H1318* | 170045 | 13/16"–1-1/8" | 21-28 | 200 [890] |
| 4H24SS | N/A | 1/8"–1/4" | 3-8 | 140 [623] |
| 4H58SS | N/A | 5/16"–1/2" | 8-14 | 140 [623] |
| 4H912SS | N/A | 9/16"–3/4" | 14-20 | 140 [623] |
*Made from spring steel
Installation for Standard Flange Applications
The clip is attached to a flange by pushing it onto the edge. A hammer may be used to secure it at a 90° angle to the flange.
Bulb Tee Applications
The Hammer-On Flange Clip can also be used with Bulb Tee profiles. The installation involves pushing the clip onto the flange and securing it, often with a hammer, at a 90° angle.
The clip can be used to attach a chain or wire, with a hole of Ø9/32 [7mm] provided for this purpose. The static load limit is indicated by a label.
- Install and use nVent products only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at www.nVent.com.
- Never use nVent products for purposes other than those for which they were designed or in a manner that exceeds specified load ratings.
- Follow all instructions completely for proper and safe installation and performance.
- Improper installation, misuse, misapplication, or failure to follow nVent's instructions and warnings may cause product malfunction, property damage, serious bodily injury, and/or death, and will void your warranty.
- Products manufactured using spring steel components are for use only in non-corrosive indoor environments.
- All pipe supports, hangers, intermediate components, and structural attachments must be used only as described herein and never for any other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water, or seismic loads, unless otherwise noted.
The customer is responsible for:
- Conformance to all governing codes.
- The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
- Using appropriate industry standard hardware.
SAFETY INSTRUCTIONS:
- Observe all governing codes and regulations and those required by the job site.
- Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.
TECHNICAL SUPPORT: www.nVent.com
