Installation Guide for AURORALIGHT models including: PTA118104 High Performance LED Path Light, PTA118104, High Performance LED Path Light, LED Path Light, Path Light
PTA118104 Centinela – Auroralight
CENTINELA INSTALL GUIDE PTA118104 INSTRUCTIONS: 1. To prevent electrical shock, disconnect transformer from electrical supply and make sure power supply is completely off before installation. Fixtures should always be installed by a licensed electrician. 2. Pound the ground stake fully into soil, stake should be plumb. 3. Loosen the set screw with the supplied Allen key and remove the ½" adapter from the stem assembly. Screw the ½" adapter into the ground stake and tighten down by hand. 4. Feed the 18GA lead wires through the ground stake and out of lead wire exit hole (see figure). FINISH GRADE 5. Slide the stem assembly into the ½" adapter until it fully stops. Tighten the set screw down to secure in place. WIRE EXIT HOLE 6. Separate the 2-conductor 18GA lead wires by pulling apart UL LISTED WIRE CONNECTOR the ends approximately 10". Strip about ½" of the insulation off the ends (see figure). 12GA LISTED SPT-3 UNDERGROUND CABLE 7. Connect the 18GA lead wires to 12GA underground supply cable using UL listed connectors suitable for underground burial or wet location (see figure for configuration). 18GA LEAD WIRE 8. Underground supply cable for power supply to this luminaire shall be SPT-3 Underground Low Energy Cable and listed as such (see figure). REQUIRED TOOLS: 3/32 Allen Key (Included) Heavy Mallet/Hammer Wire Cutter / Stripper STEM ASSEMBLY SET SCREW 1/2" ADAPTER GROUND STAKE P. 760.931.2910 E. techsupport@auroralight.com O. 2742 Loker Ave. W Carlsbad CA 92010 W. www.auroralight.com TIP: Small gauge cable is vulnerable to damage in the landscape; Protect by routing in close proximity to the luminaire or adjacent to concrete slab or similar structure. Do not bury more than 6" deep. Do not over tighten. WARNING: Luminaire must be installed in accordance with local codes and the National Electrical Code (NEC). Failure to do so may result in serious injury and or damage to the luminaire. WARNING: Risk of electric shock. Install per NEC Code 680.22(B (6), if listed low voltage luminaires are to be located near a pool, spa or fountain.Adobe PDF Library 17.0 Adobe InDesign 19.4 (Windows)