YsxLite Camera Installation Guide

Installation APP

Scan the QR code below for download and installation of the YsxLite application.

Application Name: YsxLite

[QR Code]

Connection Method 1: No Network Connection

1. Connect to the camera's Wi-Fi hotspot (starts with 'BAT'). Click 'Connect'. After successful connection, return to the APP.
2. Find your Wi-Fi account and enter the password correctly. Click 'OK' to return.
3. You can now view the video feed.

Note: Without a network link, remote monitoring is limited to within 4 meters of the camera.

For remote monitoring with your home Wi-Fi, follow these steps:

1. Open the system Wi-Fi interface.
2. Select the Wi-Fi network starting with 'BAT'.
3. Enter your Wi-Fi password and connect.
4. After the connection is displayed successfully, click 'Screen viewing'.

Connection Method 2: Internet Connection

1. Connect to the camera's Wi-Fi hotspot (starts with 'BAT'). Click 'Connect'. After successful connection, return to the APP.
2. After entering the page, follow the steps below.
3. When you return to the APP, the connection success reminder will appear. Click the play button to view the screen and complete the remote setup.

Note: Ensure the Wi-Fi password is correct for a successful link. If it fails, forget the router password, verify it, and re-enter.

FCC Compliance Information

Class B Device

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning:

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

The distance between user and products should be no less than 20cm.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.