Product Details
Product Type: Mobile Phone
Model Name: 24116RACCG
Hardware Version: 135100006
Software Version: Xiaomi HyperOS 1.0
FCC ID: 2AFZZRACCG
Test Report Notes
The test results in this test report relate only to the devices specified in this report. This report shall not be reproduced except in full without the written approval of CTTL.
The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the U.S. Government.
Test Laboratory Information
Laboratory: CTTL, Telecommunication Technology Labs, CAICT
Address: No. 52, Huayuan North Road, Haidian District, Beijing, P. R. China 100191.
Contact: Tel: +86(0)10-62304633-2512, Fax: +86(0)10-62304633-2504
Email: cttl_terminals@caict.ac.cn
Website: www.caict.ac.cn
Test Setup Visual Descriptions
Picture 1: Constituents of the sample
A mobile phone is shown alongside measuring tools, indicating it's part of a sample for testing.
Picture 2: Left Head Touch Cheek Position
A mobile phone is positioned against a simulated headform, touching the cheek area on the left side.
Picture 3: Left Head Tilt 15° Position
A mobile phone is positioned against a simulated headform, tilted 15 degrees on the left side.
Picture 4: Right Head Touch Cheek Position
A mobile phone is positioned against a simulated headform, touching the cheek area on the right side.
Picture 5: Right Head Tilt 15° Position
A mobile phone is positioned against a simulated headform, tilted 15 degrees on the right side.
Picture 6: Front 10mm
The mobile phone is positioned 10mm away from the front of the simulated headform.
Picture 7: Rear 10mm
The mobile phone is positioned 10mm away from the rear of the simulated headform.
Picture 8: Left 10mm
The mobile phone is positioned 10mm away from the left side of the simulated headform.
Picture 9: Right 10mm
The mobile phone is positioned 10mm away from the right side of the simulated headform.
Picture 10: Top 10mm
The mobile phone is positioned 10mm away from the top of the simulated headform.
Picture 11: Bottom 10mm
The mobile phone is positioned 10mm away from the bottom of the simulated headform.
Picture 12: Front 15mm
The mobile phone is positioned 15mm away from the front of the simulated headform.
Picture 13: Rear 15mm
The mobile phone is positioned 15mm away from the rear of the simulated headform.
Picture 14: Top 0mm
The mobile phone is positioned directly against the top of the simulated headform (0mm separation).
Picture 15: Bottom 0mm
The mobile phone is positioned directly against the bottom of the simulated headform (0mm separation).
Picture 16: Rear 0mm
The mobile phone is positioned directly against the rear of the simulated headform (0mm separation).
