User Guide for MONSTER models including: MH22242 Bluetooth Headphone, MH22242, Bluetooth Headphone, Headphone
Shenzhen Monster Creative Technology Co., Ltd. MH22242 BLUETOOTH HEADPHONE 2AVD2-MH22242 2AVD2MH22242 mh22242
Model No.: MH22242
Product Overview
BLUETOOTH HEADPHONE
QUICK START GUIDE
Please read this Quick Start Guide carefully and keep it for future use.
Open earphones x2 (L & R
Charging case x1
USB-C cable x1
Quick start guide and Warning card
Charging
Before using the "Monster Open Ear AC220", please connect the USB-C cable to a power adapter to begin charging. Fully charge the earphones and the charging case before the first use.
in your device and choose "Monster Open Ear AC220" from the Bluetooth list to connect. You will hear system prompts a er the earphones are connected to the device. If the earphones have been paired before, they will automatically reconnect to the previous device when turned on.
Wearing
Put the "Monster Open Ear AC220" onto your ears and rotate to fit comfortably to get the best wearing and sound quality experience.
1
2
MFB Operation
L/R 2
L/R 2
L/R 2s
L 3
L/R 2s
R 3
USB-C Port
Power On/Off
Open the cover of the charging case ,take out the earphones, the earphones will turn on automatically. If you want to turn off the earphones, please put the earphones into the charging case and close the cover,the earphones will power off and charge at the same time.
Pairing
Open the cover of the charging case ,take out the earphones, the earphones will turn on automatically.For new device connection, turn on the Bluetooth
R
L
1
1
3
4
Reset
In the power on state, touch the MFB of the earphones 5
times (two earphones at the same time),the earphones
will automatically shut down and Place the earbuds back
into the charging case to recharge. When you take them
out again, they will power on automatically and enter
pairing mode.
Additional Operation
Answer call
Press L or R twice
End call
Press L or R twice
Reject call
Press MFB on the le or right earphone
for 2 seconds
LED indicator (earphone)
Power on
White flashes
Power off
The red light on 2s and then turn off
Pairing is successful
The white light on 1s and then turn off
Pairing timed out
The red light on 2s and then turn off
Connection is over distance White flashes
Disconnect the phone
White flashes
Low battery
Red light flashes slowly
Low power off
The red light on 2s and then turn off
LED indicator (charging case)
Charging
The red light continues to flash slowly,
and the red light is full and on
Discharge
When the charging case charges the
earphones, the white light stays on and
turns off when it is full
Low battery
Place the earphones in the charging case,
the white flashes
Attention *Private replacement of batteries without permission is not recommended. *Batteries [battery packs or battery combinations] should not be exposed to lighting, baking or similar overheating environments. *The input voltage and current standard 5V/1A when charging the headset charging compartment from an external power source;
FCC STATEMENT
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. lf this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and the receiver. - Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio / TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received. Including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. FCC ID: 2AVD2-MH22242
IC CAUTION
Radio Standards Specification RSS-Gen, issue 5 - English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device.
RF exposure statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
- French: Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes: Cet appareil ne doit pas causer d'interférences. Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil.
Déclaration d'exposition RF: L'appareil a été évalué pour répondre aux exigences générales d'exposition aux RF. L'appareil peut être utilisé dans des conditions d'exposition portable sans restriction. IC: 28087-MH22242
Model No.: MH22242
BLUETOOTH HEADPHONE
x2 (&
x1
USB-C x1
/
USB-C
" Monster Open Ear AC220 "
1
2
USB-C
" Monster Open Ear AC220 "
3
4
L/R 2
L/R 2
L/R 2s
L 3
L/R 2s
R 3
R
L
1
1
5
LED LED
MFB2
2S 1S 2S 2S
,
* *[]
* V/A
75X95MM 105G+1k+186C+
SJ/T-
(Pb)
(Hg) (Cd) (Cr(VI))
(PBBs)
(PBDEs)
X
O:GB/T X: GB/T
SN
Adobe PDF library 16.04 Adobe Illustrator(R) 24.0