Product Overview
The WSXE101 is a remote control transmitter designed for various applications. It features a user-friendly interface with a display screen and multiple control buttons.
The remote control has a rectangular form factor. At the top is a display screen that shows operational status. Below the screen, buttons are arranged for navigation and control. These typically include power, mode selection, up/down adjustments, selection confirmation, and group/channel assignment functions.
The device utilizes a 3V Direct Current CR2032 coin cell battery, housed in a compartment accessible from the rear of the unit.
Battery Information
The remote control operates using a 3V Direct Current CR2032 coin cell battery. The battery compartment is located on the back of the device.
Battery Safety Warning: This product contains a coin cell battery. If swallowed, it can cause severe internal burns in as little as two hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
Coding Procedure
The coding procedure is necessary to pair the WSXE101 remote control with the target receiver units. This process establishes a communication link between the transmitter and the devices it controls. Specific instructions for coding will depend on the system being integrated.
Control Modes
The WSXE101 supports both single unit control and group control functionalities.
Single Unit Control
In single unit control mode, the remote can directly manage a specific unit. The display screen will indicate the unit being controlled and its current status or settings.
Group Control (A-Unit Control)
This mode allows users to manage multiple units simultaneously by assigning them to specific groups. The display typically shows the group channel (CH) and the address (AD) of the units within the group. Users can select a group, assign units to it, and then send commands to all units in that group. Example display indicators include channel numbers (9-16), unit addresses, and ON/OFF status.
Group Control (B-Unit Control)
Similar to Group Control A, this mode facilitates managing units in predefined groups. The interface and operation are consistent with group control principles, allowing for efficient management of multiple devices.
Group Control (C-Unit Control)
Group Control C offers another configuration for managing multiple units as a group. The system allows for flexible assignment and control of devices based on group configurations.
FCC Compliance Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
