LTV50 TV Stand Assembly Instructions
Introduction
Please read the following instructions carefully and use the product accordingly.
Please keep this manual and hand it over when you transfer the product.
This summary may not include every detail of all variations and considered steps. Please contact EUZIEL International GmbH when further information and help are needed.
Notes
The product must be assembled and used in accordance with the provisions of the manual. Personal injury and/or damage to the product may occur if products are used outside of their intended purposes and/or if products have been changed/modified from their original design. EUZIEL International GmbH does not assume any responsibility or liability with respect to any damage caused by incorrect assembly or improper use.
During assembly, first loosely align all screws with the corresponding pre-drilled holes and then tighten the screws one by one.
Please use the product indoors and don't place it in a damp environment for extended periods of time to prevent mildew.
Periodically inspect screw tightness while the product is in use. If necessary, re-tighten to ensure structural integrity.
It is recommended that two adults assemble the product.
Warnings
During assembly, keep all small parts out of the reach of children. It may be fatal if swallowed or inhaled.
Children are not allowed to climb or stand on the product to avoid personal injury caused by the product tilting or tipping over.
To avoid the potential dangers of suffocation, please keep all parts and packaging (film, plastic bags, foam, etc.) away from babies and children.
Keep the product away from sharp objects or corrosive chemicals to prevent damage to the surface or cause personal injury.
The maximum load capacity of the top and middle board is 30 kg (66 lb) respectively, and that of the bottom mesh shelf is 10 kg (22 lb). Please do not place overweight items on the product.
Please do not use the product if there is/are defective and/or missing part/s, as this can result in damage or injury.
Parts List
- Part A: 1 piece (Dimensions: 1400 x 400 x 15 mm)
- Part B: 1 piece (Dimensions: 1390 x 390 x 15 mm)
- Part C: 2 pieces
- Part D: 2 pieces
- Part E: 2 pieces
- Part F: 24 pieces (Screws: 1/4" x 15mm)
- Part G: 12 pieces (Screws: 1/4" x 40mm)
- Part H: 4 pieces
- Part I: 1 piece
Note: The diagrams on pages 6-11 illustrate the parts and assembly steps. Specific screw types (F, G) and quantities are listed above.
Assembly Instructions
General Assembly Tip: During assembly, first loosely align all screws with the corresponding pre-drilled holes and then tighten the screws one by one.
Step 1: Preparation
Ensure all parts are present and undamaged. Lay out parts on a protected surface.
Step 2: Attaching Supports to Top Panel
Take Part A (main top panel). Attach two Part E pieces to the designated slots on Part A using two Part H screws for each connection (total 4x Part H screws).
Step 3: Connecting Base and Side Panels
Attach Part B (bottom panel) to the side panels (Part C). Secure these connections using 8x Part F screws.
Step 4: Attaching Shelves
Attach the middle shelf (Part C) and another shelf (Part D) to the assembled structure. Secure these shelves using Part F screws. The diagram indicates 8x Part F screws are used in this step for one shelf.
Step 5: Attaching Remaining Shelf
Attach the remaining shelf (likely another Part D) to the main panel (Part A) or the structure. Secure using 8x Part F screws.
Step 6: Final Assembly
Complete the assembly by attaching the final piece (Part I) and ensuring all screws are tightened securely. The product is now ready for use.
Manufacturer: EUZIEL International GmbH
[CE marking] is present on the product.