PNI DBA27 Base Station Antenna
Model: PNI DBA27
Installation Instructions
Follow these steps to assemble the PNI DBA27 Base Station Antenna:
- Screw the second segment of the antenna onto the base structure. Fix the two segments with 2 screws.
- Screw the third segment of the antenna onto the previously mounted segment. Fix the two segments with 2 screws.
- Screw the fourth segment of the antenna onto the previously mounted segment. Fix the two segments with 2 screws.
- Screw the fifth segment of the antenna onto the previously mounted segment. Fix the two segments with 2 screws.
- Screw the sixth segment of the antenna onto the previously mounted segment. Fix the two segments with 2 screws.
- Fix the base of the antenna to the pole using screws.
- Screw in the 3 metal rods.
- Connect the cable to the SO239 connector of the antenna.
Technical Specifications
| Frequency range | 25 - 30 MHz |
| Bandwidth | 5 MHz |
| Polarization | Vertical |
| Impedance | 50 Ohm |
| Gain | 5.5 dBi |
| Radiation | Omnidirectional |
| Horizontal beam width | 360° |
| Vertical beam width | 20° |
| VSWR | ≤1.5 |
| Lightning protection | Direct Grounding |
| Connector | SO-239 |
| Dimensions | Ø36 x 6200 mm |
| Length | 6200mm |
| Radiant material | Copper |
| Antenna material | Aluminum alloy |
| Operating temperature | -26°C ~ +80°C |
Declaration of Conformity
EU Simplified Declaration of Conformity
SC ONLINESHOP SRL declares that the Base antenna PNI DBA27 complies with Directive EMC 2014/30/EU and ROHS 2011/65/EU.
The full text of the EU declaration of conformity is available at the following Internet address: https://www.mypni.eu/products/9228/download/certifications
mypni.eu/products/9228/download/certifications
