Introduction
The MAT-TUNER mAT-30 is an automatic antenna tuner designed for seamless integration with modern Yaesu transceivers. It is compatible with Yaesu models supporting FC-30, FC-40, or FC-50 tuners, including popular units like the FT-100, FT-857, FT-897, FT-450D, and FT-891. The tuner operates within the 3MHz to 54MHz range and connects via the transceiver's CAT/LINEAR jack for both control and power, eliminating the need for an external power supply. Tuning is initiated with a simple press of the transceiver's TUNE button.
The mAT-30 offers automatic antenna tuning across the HF spectrum and 6 meters, supporting power levels up to 120 watts. It is capable of matching a wide variety of antennas, including dipoles, verticals, Yagis, and virtually any coax-fed antenna, offering a broad impedance matching range.
Featuring advanced memory tuning with 16,000 memory locations, the mAT-30 recalls previous tuning settings for near-instantaneous adjustments. It learns user preferences over time, adapting to bands and frequencies for optimized performance. The tuner also supports manual tuning cycles when necessary.
Specifications
- Power Handling: 0.1 to 120 watts SSB/CW peak, 30 watts digital modes, 100 watts on 6 meters.
- Relays: Latching relays for ultra-low power operation.
- Memory: 16,000 memories for rapid frequency and band changes.
- Coverage: 1.8 to 54.0 MHz.
- Antenna Compatibility: Dipoles, verticals, Vees, beams, long wire, and coax-fed antennas.
- Dimensions: 20cm x 13cm x 4cm.
- Weight: 0.8Kg.
Key Features
- Controlled via Yaesu TUNE button on the radio.
- Powered directly from the Yaesu radio.
- Tuning time: 0.1 to 5 seconds for full tune, 0.1 seconds for memory tune.
- Includes interface cable.
Important Note on Power Levels
The mAT-30 is rated for a maximum input power of 125 watts. Exceeding this limit can cause damage to the tuner and potentially the connected transceiver or amplifier. Always adhere to the specified power limitations.
Connections
- ANTENNA: Connect the 50-ohm coax antenna feedline.
- RF IN: Connect a 50-ohm coax jumper cable from the transceiver's ANT jack.
- Radio: Connect the supplied radio interface cable to the transceiver's CAT/LINEAR or TUN/LIN jack.
- GND: Connect to the antenna system ground for enhanced performance and safety.
Technical Support
For further assistance, product manuals, specifications, and dealer information, visit the MAT-TUNER Support Center at www.mat-tuner.com.
Product Feedback
MAT-TUNER encourages product feedback. Share your experiences with the mAT-30 by emailing your comments to help improve products and services.
