USER MANUAL

Hereby, MOB, declares that item MO2720 is in Compliance with the essential requirements and other relevant conditions of Regulation (EU) 2023/988. The full text of the EU declaration of conformity is available at the following internet address: www.momanual.com.

MOB, PO BOX 644, 6710 BP (NL).

[recycling symbol]

PO: 41-xxxxx

Made in China

MO2720 Hot water bottle

English (EN)

WARNING

HOT WATER BOTTLES CAN CAUSE BURNS. AVOID PROLONGED DIRECT CONTACT WITH THE SKIN.

Instructions

• This hot water bottle is designed for partial filling.
• When filling, do not use boiling water and fill to a maximum of two-thirds capacity or less. Do not overfill as this might cause the bottle to burst.
• Hold the bottle by the neck in an upright position and fill slowly to avoid hot water splashing back.
• Expel air from the bottle by lowering it carefully onto a flat surface until water appears at the opening.
• Screw the stopper sufficiently tight to ensure that there is no leakage. Tightened by hand should be adequate.
• Finally, make sure the funnel is empty.
• If there is a possibility that prolonged contact with the skin could occur, an adequate cover should be used to prevent burns.
• Under no circumstance should the hot water bottle be used as a cushion and be sat on.
• Do not fill using water from the domestic hot water system as this can considerably shorten the life of the hot water bottle.
• Prevent contact with hot surfaces.
• Prevent contact with oil or grease.
• When not in use, drain completely and keep, with the stopper removed, in a cool, dry, dark place. Prevent exposure to sunlight.
• Do not place anything on top of the bottle during storage.
• Check the bottle and stopper for wear and damage prior to use.
• Do not use this water bottle to hold drinks.
• Retain these instructions for future reference.