User Manual for URBAN VITAMIN models including: 2AMNTPUP-0430, PUP0430, PUP-0430 10000mAh Multifunctional Power Charger, PUP-0430, 10000mAh Multifunctional Power Charger, Multifunctional Power Charger, Power Charger, Charger
Curv Group LLC PUP-0430 2AMNTPUP-0430 2AMNTPUP0430 pup 0430
Multifunctional Power Charger lOOOOmAh
PUP-0430
User Munual
Product Diagram
86m m
F L c n p H c ld p r
I
I
86mm
Product Parameter
Model PUP-0430
Mat,al F,cepmof ABS<PC
Capac;ty, 10000mAh/37Wh
AClopot100-240VACSOH,/60H, 0.3A{Ma,)
Type-C lcpot DC5V-12V PD18W M
Type-C Ootpot DCSV-12V PO 20WMa,
Type-CCableOotpot DC5V{3A Ma,
LightoiogCableOotpot DC5/2.4A Ma,
USBOctpct DC5V/45A,9V/2A,12V/l5A 22SWMa, Wlcele;;Octpct 15WMa,
I
S,e 86mm"86mm"34mm
NW., 260g
Packing List
PS-8003
UsecMacoal
ColocBo,
User Guide
Wall Charge
lI Phone Holder
lIE
Power Bank
Wireless Charger
Applicable Scope And Charging Methods
1 Product function 4 output pocan chage ,arious de,ices at the samet,me Withmobilephone holder function
2. Power supply, When the power of the product is low, the product can be powered by a charging cable though USB port such as a compute, ACadapte0 ca chage
Charging Instruction I. Powecstatus when it's being chacged
When chacging, the digital tube flashes and displays the cueent powecstatus. When fully chacged, it displays"l00%" and the light cemains on 2. Powecstatus when chacging othedCN,ces When dischaging, the d,gital tube light emains on show,ng the cucent battery pecentage. When the powe, is lowe,than 5%, the digital tube flashes to indicate low battery. When in the low powec state, the d,g,tal tube d,splays 0% and ftashin& also the battecy ,oltage is lowethan 3V, the pcoduct is automatically off
Attention
There is a r,skof explosion if the battery ,s incorrectly replaced Only cse batteries of the same type or eq,,,alent for replacement
FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Microsoft: Print To PDF