Installation Guide for TCP models including: TCP, Snap-In, Downlights
Hold to clip springs vertically, and slowly insert the fixture into the hole in the ceiling. The fixture will be successfully installed.
Snap-In Downlights Installation Instructions INSTALLATION INSTRUCTIONS WARNING! RISK OF ELECTRIC SHOCK! DISCONNECT POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING OR SERVICING! STEP #1 POWER OFF TURN OFF POWER AT CIRCUIT BREAKER to prevent risk of electric shock. STEP #2 Allow adequate space in ceiling cavity for heat dissipation. Height of cavity should be at least 60mm (2.4") 60mm. STEP #3 Hole Ceiling Drywall Saw Carefully make a fixture installation hole in the ceiling using a drywall saw. STEP #4 STEP #5 STEP #6 Have qualified Electrician install supplied electrical box. STEP #7 Connect male electrical lead from the downlight with the female lead from the electrical box. STEP #8 Once inserted, make sure connection is secure by twisting until tab is locked in slot. Hold to clip springs vertically, and slowly insert the fixture into the hole in the ceiling. The fixture will be successfully installed when it is flush against the ceiling. POWER ON Restore power to recessed fixture at circuit breaker. Enjoy energy-efficient LED lighting, and up to 80% energy savings vs. equivalent incandescent bulbs. TCP® 325 Campus Dr. | Aurora, Ohio 44202 | P: 800-324-1496 | tcpi.com ©TCP SEP 2020/WF218700Adobe PDF Library 15.0 Adobe InDesign 15.0 (Macintosh)