User Guide for phrozen models including: Cure Mega S Post Curing UV Lamp, Post Curing UV Lamp, Curing UV Lamp, UV Lamp, Lamp
Manual | Phrozen Technology: Resin 3D Printer Manufacturer
il y a 9 heures — Please visit our Users Guide for more information. User Guide. 3. 4. Removable Rack. Turntable. Power Switch. Touch Panel. Side Acrylic Door. Interior Light.
21 hours ago — In case of contact with uncured resin and alcohol (cleaning fluid), please rinse immediately with plenty of water. Instructions. 02. Install the turntable into ...
Phrozen Cure Mega S User Guide Post-Curing UV Lamp Interior Light Side Acrylic Door Touch Panel Specifications Product Dimension39.5 x 47.5 x 48.6 cm Maximum Model SizeØ25 x 30 cm Fan Speed1700 rotations/min Timer1120 min Recommended timeMaximum 30 minutes/cycle InputAC 100-240 V ; 50/60 Hz Weight15 kg Rated Power70 W LED Wavelength405 nm Light intensity22000±2000 w/cm2 (measured on the turntable, 10 cm from side LEDs) Removable Rack Turntable Power Switch Adjustable interior light Dry and cure models consecutively Dry prints Cure prints Change timer Start the process Return to the homepage Remaining time Stop progress temporarily End progress and return to homepage 01 Before You Start Place the machine on a clean and level surface. Please make sure to wear protective goggles when handling the machine. Remove the rack when drying and curing large models. 02 Instructions 1 Install the turntable into the machine and connect the power. 2 Make sure the models have been thoroughly cleaned without any residual resin before curing. 3 Place the model on the turntable or the rack and cover the door before starting the machine. 4 SelectCure, Fan, or Fan + Cure according to your needs. 5 To have a better view of the models inside, feel free to turn the interior lights. 6 Input the required time and press ENTER. It's recommended to set max. 30 mins/cycle. 7 Please remember to take out the model after the curing process ends. 3 4 Note : Freshly cured model might get hot; please remove it carefully. The recommended curing time of 30 minutes might not be suitable for every resin. Please visit our Users Guide for more information. 6TFS(VJEF Warning Disconnect the power cable before performing maintenance. DO NOT open the acrylic door while the machine is running. Avoid direct contact with uncured resin and other cleaning fluids to prevent allergies. In case of contact with uncured resin and alcohol (cleaning fluid), please rinse immediately with plenty of water. )FMQ$FOUFS 'BDFCPPL :PV5VCF *OTUBHSBNAdobe PDF library 17.00 Adobe Illustrator 28.0 (Windows)