Installation Guide for Pamex models including: KP1DS, 2AQ8A-KP1DS, 2AQ8AKP1DS, KP1-DS Kapture Door Sensor, Kapture Door Sensor, Door Sensor, Sensor
Pamex Inc. KP1DS Kapture Door Sensor 2AQ8A-KP1DS 2AQ8AKP1DS kp1ds
Door Sensor 1 Door Sensor Installation Model : KP1-DS Table Of Contents Inside the box 1 Installation Instructions 3 Light Indicator Chart 9 FCC statement 13 Inside the box Sensor piece Magnet piece 1 4x Sensor Sticker Magnet Sticker Screws 2 First Way - Install with Screws Step1. Open Cover You can use any tool to open the cover from the bottom of door sensor. Installation Instructions There are two installation ways, choose one or both. Open Sensor Piece Open Magnet Piece 3 4 First Way - Install with Screws Step2. Mark and drill hole location Use the sensor/magnet mounting part to mark and drill the mounting holes. Notice Please make sure the object thickness is no less than 1-1/4". 1/8" 1/8" 2" 1-3/4" 1-1/4" Sensor Mounting Part Magnet Mounting Part 5 Side View 6 First Way - Install with Screws Step3. Installation After installing the screws, close the cover. Note that not only the wall, you can also install it wherever you need it, such as a window, door...etc. 7 Sensor Magnet 8 Second Way - Install with Stickers Step1. Installation Only use stickers to fix door sensor. Note that not only the wall, you can also install it wherever you need it, such as a window, door...etc. 9 Sensor Magnet 10 Light Indicator Chart Door Sensor Away - Flash 1 Red LED Door Sensor Connect - Flash 1 Green LED Effective distance is less than 1-1/2". Less than 1-1/2" 11 12 FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. 13 If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures : - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and a human body. 14 15Adobe PDF Library 16.0.3 Adobe InDesign 17.0 (Macintosh)