Yealink Support
Installation Guide for Yealink models including: UVC40-E2 Intelligent USB Video Bar, UVC40-E2, Intelligent USB Video Bar, USB Video Bar, Video Bar
File Info : application/pdf, 7 Pages, 543.81KB
DocumentDocumentUVC40 E2 Installation UVC40 E2 Installation Package Contents TIP We recommend that you use the accessories provided or approved by Yealink. The use of unapproved third-party accessories may result in poor performance. Use the Yealink original power adapter (48V/0.7A) to charge the endpoint only. The use of a third-party power adapter may cause damage to the endpoint. 1 Install UVC40 E2 Put on a Flat Surface UVC40 E2 Installation Mount on a Wall 2 UVC40 E2 Installation Adjust Camera Tilt 3 Mount on the Tabletop Mount UVC40 E2 Installation Mount Above a TV or a Display 4 UVC40 E2 Installation NOTE The M-2 bracket can be inserted into the M-1 in two directions. Here, we take one direction as an example. Due to the device's weight, it is advisable to avoid mounting the device on slim TVs to prevent potential falls or damage to the screen. Hardware Interface Please refer to MVC Hardware Overview-UVC40 E2 Camera for details. Connect UVC40 E2 Connect with VCM35 5 UVC40 E2 Installation NOTE When connecting the VCM35, ensure that the Network of the UVC40 E2 is disabled on the Yealink RoomConnect (disabled by default; default password: admin). Only then can the VCM35 be utilized. Connect with VCM36-W Pairing Directly 1. Connect the USB-C port on the VCM36-W to the USB port on the UVC E2 using the USB (A-C) cable. The Mute LED indicator will fast-flash yellow during pairing. Once the flashing ceases, it indicates a successful pairing state. You can also verify this on the Yealink RoomConnect software. 2. Disconnect the cable, then you can use the VCM36-W. Pairing by Yealink RoomConnect Software 1. Connect the USB-C port on the VCM36-W to the USB port on the PC using the USB-C cable. 2. Connect the Video Out port on the UVC camera/AV Hub to the same PC using the USB-B cable. 3. Run the Yealink RoomConnect software on the PC. The Mute LED indicator will fast-flash yellow during pairing. After successful pairing, the VCM36-W card appears on the Yealink RoomConnect software. 4. Disconnect the cable, then you can use the VCM36-W. NOTE The VCM36-W and the VCM35 can only be used one at a time. LED Indicator LED Status Description 6 UVC40 E2 Installation Off The UVC40 E2 is not properly connected to the PC. Solid Green The UVC40 E2 is active. Flash Green There is an incoming call. Solid Red The UVC40 E2 is muted. Flash Red The UVC40 E2 is in recovery mode, and the firmware has not been upgraded. Solid Orange The UVC40 E2 is initializing or in sleep mode. Flash Orange The UVC40 E2 is upgrading firmware. Flash Red and Green Alternately The UVC40 E2 is paired with the VCM36-W. 7