ERGB1 2.4G Remote Control Racing Boat Manual

Thank you for purchasing the ERCB1 Remote control racing boat. Please ensure that you have read the product manual and instructions in full, prior to use. Failure to do so may result in product failure/damage or incorrect operation and therefore impact the products performance.

Product Features

Maximum speed: 25 km/h
Maximum running time: 15 minutes
Maximum controlling range: 100 metres
Charging time: 120 mins
180 degree flip function
Low battery warning
Boat size: 35.5 x 10 x 8.5 cm
Boat weight: 360.5 g

Inclusions

2.4G Remote control boat
Remote controller
Display boat rack
Li-PO 7.4V 600mAh rechargeable battery

Not Included

3x1.5V "AA" alkaline batteries for remote controller

RC Boat Main Structure Diagram

The main structure of the RC boat includes:

Outer hatch
Inner hatch
Switch of hatch
Anti-collision rubber sleeve
Steering engine bar
Steering rudder
Guiding rudder
Propeller
Outfall

The remote controller features:

Power Indicator
Forward trim
Backward trim
Turn left Trim
Turn right Trim
Throttle rocker (Forward/Backward control)
Direction rocker (Turn left/Turn right control)
High / Low speed switching button
Power switch

The boat display rack is a stand for the boat.

Battery Installation

To install batteries in the remote controller:

Remove the battery cover on the back of the remote controller.
Insert 3x1.5V "AA" alkaline batteries, observing the polarity markings within the battery compartment.

Warning:

Install batteries with correct polarity.
Do not mix old and new batteries.
Do not mix different types of batteries.
Non-rechargeable batteries cannot be charged.

Charging the Boat's Rechargeable Battery

The boat uses a USB charging method.

Connect the USB end of the provided cable to a computer or power source.
Connect the charger plug end of the USB to the boat's rechargeable battery.

The red indicator light turns on during charging and turns off when charging is complete. A full charge takes approximately 2 hours.

Warning:

The rechargeable battery must be charged under adult supervision.
Only use the USB data cable provided by the manufacturer for charging.
The battery charging voltage cannot exceed 9V.

Inserting the Rechargeable Battery into the Boat

Open the outer hatch by turning the locking switch to the right or left.
Open the inner hatch by turning the 3 locking switches.
Place the Li-PO battery into the battery holder inside the hull.
Connect the power plug to the battery.
Replace the inner hatch at a diagonal angle to the boat body.
Close the inner hatch by turning the 3 locking switches.
Replace the outer hatch.
Close the outer hatch by turning the locking switch.

Pairing the Boat with the Remote Controller

Connect the boat's battery and place the boat in the water.
Turn on the remote control switch. The remote control LED indicator light will flash continuously and emit a "beep" sound.
Once successfully paired, the remote control LED indicator light will stay on.
A flashing LED indicator and "beep" sound indicate low batteries (either boat or remote). Return the boat to shore or replace/recharge batteries.

Warnings

Read the manual before use.
This product is suitable for ages 14 and above.
Allow the battery to cool down before charging after use.
Use only the designated battery charger.
Do not over-charge the battery.
Ensure the operating area is free of people or debris when using the boat.
Keep all body parts away from the spinning propeller to avoid injury.
Disconnect the power supply when the boat is not in use.
The motor may be hot after use; do not touch to avoid scalding.
Regularly check cables and parts for damage. Do not use if damaged.
Store small parts out of reach of children.

Remote Control Operation

1. Forward: Push the throttle lever forward. The boat moves forward.

2. Backward: Push the throttle lever backward. The boat moves backward.

3. Turn Left: Push the throttle lever forward and the direction rocker left simultaneously. The boat turns left.

4. Turn Right: Push the throttle lever forward and the direction rocker right simultaneously. The boat turns right.

5. Turn Left Trim: If the boat drifts right, press the "turn left trim" button for fine adjustment until it travels straight.

6. Turn Right Trim: If the boat drifts left, press the "turn right trim" button for fine adjustment until it travels straight.

7. Backward Trim: If the boat moves forward when the throttle is neutral, press the "backward trim" button until it stops moving forward.

8. Forward Trim: If the boat moves backward when the throttle is neutral, press the "forward trim" button until it stops moving backward.

9. Capsize Recovery (180° Flip): If the boat overturns, push the throttle stick forwards and backwards continuously until the boat rights itself.

Maintenance and Storage

After use or storage, disconnect the rechargeable battery.
Wipe the boat's surface with a dry cloth to remove excess moisture.
Remove remote controller batteries to prevent leakage and damage.

Note: After play, use a dry cloth to remove any moisture inside the hull and ensure it is dry. After use in salt water, clean the boat with fresh water.

Technical Assistance

For assistance with setup or usage issues, contact EOSS Customer Support:

TEL: 03 – 8587 8898
FAX: 03 – 8587 8866
Hours: Mon-Fri 9am – 5pm AEST

This manual and product information are considered correct at the time of printing but are subject to change. For the latest manuals and updates, refer to the website: TDJ.com.au/help-downloads.