Knog Blinder E 2300 Quick Start Guide

What's in the Pack

• 1. BLINDER 2300 LIGHTHEAD
• 2. E-BIKE CABLE
• 3. BAR-MOUNT (PRE-INSTALLED)
• 4. SHIMS 31.8MM / 35MM (35MM PRE-INSTALLED)
• 5. HEX KEY
• 6. TORX SCREWDRIVER

Important Information

Knog's E-bike lights are powered by the lighting output of an e-bike motor and require electrical installation, potentially involving e-bike disassembly and additional wiring. Ensure your e-bike's lighting output capability matches the power requirement of the Blinder E-bike light before installation. Contact your e-bike/e-bike motor manufacturer for detailed instructions. Note that any disassembly may void your warranty. Knog advises having a trained professional install your Blinder E-bike light.

Note: Refer to the Power Scaling Mode section for instructions on how to scale down the power requirements of the Blinder E-bike light to suit e-bikes with lower lighting power outputs.

Technical Data

• Output: 2300 Lumen
• Wattage: 20W
• Input Voltage: 12V (5-14V) DC-AC
• Mounting: Bar-mount

Mounting Instructions

1. Use the provided hex key to install the mount to the lighthead (in most cases, the lighthead & bar-mount will be pre-installed).
2. Use the hex key to tighten the bolt and secure the bar-mount to the lighthead.
3. Loosen the bolt at the base of the bar-mount and separate at the hinge.
4. Ensure you have installed the correct sized shim to suit your handlebar.
5. Use the hex key to tighten the bolt and secure the bar-mount to the handlebar.

Adjusting the Beam Angle

1. Use the hex key to loosen the bolt and rotate the lighthead to your chosen angle.
2. Use the hex key to tighten the bolt and lock the light at the chosen angle.

Installation & Wiring

Knog recommends that their Blinder E-bike lights be installed by a professional. The diagram below shows the polarity of the supplied e-bike cable and is for general information only.

E-bike Cable Polarity:

• RED: POSITIVE
• BLACK: NEGATIVE

Important: Before installation, ensure your e-bike motor has a light output. Do not attempt to connect your Blinder E-bike light directly to your e-bike battery.

Operation

Power Button

• Single Press: To power on or off.
• Double Press: To toggle between steady & flashing mode banks.
• Quick Press: To advance to the next mode.

Status LED

• The Status LED will shine blue when the light is in High mode.
• For all other modes, the Status LED will shine green.

Power Scaling Mode

The e-bike lighting output power capability varies between brand and model. The Power Scaling Mode offered on Knog Blinder light heads allows the maximum power requirement of the light head to be adjusted to match the capabilities of the e-bike.

To Access Power Scaling Mode:

1. Starting with your e-bike and lighting output turned OFF, hold down the Knog Power Button.
2. Turn ON your e-bike and its light output.
3. Release the Knog Power Button.
4. In Power Scaling Mode, the main LEDs on the light head will be OFF, and the selected power level will be indicated by the flashing Status LED.
5. A short press of the Power Button will toggle through the power levels.

Power Levels:

• Power Level 1: 6W (1 Flash Green)
• Power Level 2: 9W (2 Flashes Green)
• Power Level 3: 12W (3 Flashes Green)
• Power Level 4: 14W (4 Flashes Blue)

Long press the remote power button to save the power level and exit Power Scaling Mode.

Modes

Note: This table refers to outputs in Power Scaling Mode-4.

Product Information

Designed by Knog, Melbourne, Australia.

2 Year Warranty

Visit: knog.com