DC 12V 1CH Learning Code Remote Control Switch

Remote Receiver Specification

Operating Voltage: 12V DC
Receiving Range: 328ft (Open space)
Mode: Momentary/Toggle/Latched/ Delay Mode
RF Frequency: 433MHz
DC Encoding Type: Learning code
RF Channel: One
Transmitter Support: Max 35
Output Terminals: NO/NC/COM
Connectors: 5 screw Terminal
Case Construction: ABS Plastic

The device includes a remote control with two buttons, labeled Button A and Button B, and a receiver unit with a learning button.

4 Operating Modes

Momentary Mode: Press and hold Button A for ON, release Button A for OFF.
Toggle Mode: Press Button A for ON, press Button A again for OFF.
Latched Mode: Press Button A for ON, press Button B for OFF.
Delay Mode: Press Button A for ON, after a fixed duration, it returns to OFF. This mode supports fixed delays of 5s, 10s, 15s, or 20s.

The item is set to Latched Mode by default. Users can configure other modes as needed.

How to Reset

Press the learning button 8 times. After a reset, all previously paired transmitters will no longer function and require re-learning.

How to Set Different Modes

Momentary Mode: Press the Learning Button 1 time. The LED indicator will flash 1 time. Then, press Button A. The LED indicator will flash 3 times, indicating successful learning.
Toggle Mode: Press the Learning Button 2 times. The LED indicator will flash 2 times. Then, press Button A. The LED indicator will flash 3 times, indicating successful learning.
Latched Mode: Press the Learning Button 3 times. The LED indicator will flash 3 times. Then, press Button A. After 3 seconds, press Button B. The LED indicator will flash 3 times, indicating successful learning.
Delay 5s Mode: Press the Learning Button 4 times. The LED indicator will flash 4 times. Then, press Button A. The LED indicator will flash 3 times, indicating successful learning.
Delay 10s Mode: Press the Learning Button 5 times. The LED indicator will flash 5 times. Then, press Button A. The LED indicator will flash 3 times, indicating successful learning.
Delay 15s Mode: Press the Learning Button 6 times. The LED indicator will flash 6 times. Then, press Button A. The LED indicator will flash 3 times, indicating successful learning.
Delay 20s Mode: Press the Learning Button 7 times. The LED indicator will flash 7 times. Then, press Button A. The LED indicator will flash 3 times, indicating successful learning.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna; Increase the separation between the equipment and receiver; Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.