Hotone Verbera Quick Start Guide

Controls and Functions

1. DECAY
   ALT-IR: Adjusts the decay of the Convolution Reverb (IR).
   ALT-XR: Adjusts the decay of the Extra Reverb (XR).
2. ATK/PRE-DL
   ALT-IR: Adjusts the attack of the Convolution Reverb (IR).
   ALT-GLOBAL: Adjusts the pre-delay of the entire wet signal.
3. TONE/MOD
   ALT-GLOBAL: Adjusts the brightness of the wet signal.
   ALT-GLOBAL: Adjusts the depth of the wet signal's modulation.
4. PRESET
   Rotate: Cycles through saved presets.
   Press: Saves the current preset to a specified location or renames it.
   Long Press: Directly saves the preset to the current location.
5. MIX
   ALT + IR: Adjusts the dry/wet mix of the Convolution Reverb.
   ALT + XR: Adjusts the dry/wet mix of the Extra Reverb (XR).
6. IR
   Rotate: Cycles through saved IRs.
   Press: Sorts all IRs sequentially according to different rules.
7. ALT/MENU
   Press: Switches between two functions for each knob. Each knob has the following functions:
   ALT + IR: Adjusts IR parameters.
   ALT + XR: Adjusts additional reverb parameters.
   ALT + GLOBAL: Adjusts parameters for the entire wet signal.
   Long Press: Enters the MENU interface.
8. CLONE
   Long Press: Enters the IR cloning process.
9. ALT + CLONE
   Enters the EXP setting interface for the current preset.
10. 10 & 11. ACTIVE / FREEZE
    Switching between Stomp Mode and Control Mode: Control Mode / Preset Mode.
    Control Mode:
    ACTIVE: Toggles reverb on/off.
    FREEZE: Toggles the reverb freeze function on/off.
    Preset Mode:
    ACTIVE: Switches to the previous preset.
    FREEZE: Switches to the next preset.
11. 12. Input
    Selects the input mode: Mono/Stereo/Auto.
    For mono input: Connect a mono instrument using a 1/4-inch TS cable.
    For stereo input: Connect stereo equipment using a 1/4-inch TRS cable or a Y-cable (shown below).
12. 13 & 14. Output
    For mono output: Connect the OUT L/STEREO channel to a mono input device using a 1/4-inch TS cable.
    For stereo output:
    1. Connect the OUT L/STEREO channel to a stereo device with a TRS input using a 1/4-inch TRS cable.
    2. Connect the OUT L/STEREO channel and OUT R channel to a stereo device with dual TS inputs using two 1/4-inch TS cables.
13. 15. Power Connection
    Power input (9V DC, 1A, center-negative).
14. 16. USB
    The USB 2.0 Type-C jack is for connecting to dedicated software for IR control and preset management. It supports USB PD protocol for power delivery.
15. 17. MIDI THRU
    A standard MIDI thru interface for transferring MIDI messages via an 1/8-inch TRS cable.
16. 18. MIDI IN/EXP
    Set the control mode to EXP/MIDI in the MENU. Connect MIDI devices or an expression pedal using an 1/8-inch TRS cable.

Additional Information

The user manual can be downloaded from the website:

https://allaccess.co.jp/hotone/

Hotone Japan General Distributor:
All Access International Co., Ltd.