Veloretti Electric Training Wheels Mounting
Product Information
Manual: Training wheels mounting
Version: 1.1.
Year: 2023
Manufacturer: Veloretti BV
Tools/Products Needed
- Wrench 15
Mounting Instructions
Riding a bike is a cool challenge for your kid, training wheels can help! If you have the right feeling and you can keep your balance, you can remove the training wheels.
- Open the rear axle bolt with wrench 15 and take the ring and nut off.
- Put the parts over it in this order: Spacer, training wheels, ring, and the nut.
- The wheels should be mounted a bit above the ground to only give support once your little one loses balance.
- Tighten the bolt with wrench 15 (20 Nm).
Tip: Make sure the wheel is fully aligned with the frame and the chain is at the right tension.
Diagram Description
The diagram illustrates the process of attaching training wheels to the rear axle of a bicycle. It shows the rear wheel hub, axle nut, a spacer, the training wheel arm, and the outer nut. A dashed red line indicates the sequence of parts to be placed onto the axle bolt: first a spacer, then the training wheel assembly, followed by the original ring and nut. The diagram also shows the axle bolt, nuts, and the mounting bracket for the training wheel.
