Kuzco Lighting
Installation Guide for KUZCO models including: AT68010, All Terior LED Wall Sconce, AT68010 All Terior LED Wall Sconce
Slate AT68010 – Kuzco Lighting
Kuzco Lighting AT68010-BG Slate 9.88 inch Black with Brushed Nickel ADA Wall Sconce Wall Light in Brushed Gold
Kuzco Lighting AT68010-BK Black Slate 6" Tall LED Wall Sconce - LightingDirect.com
File Info : application/pdf, 1 Pages, 464.50KB
DocumentDocumentAll-Terior LED Wall Sconce AT68010 INSTALLATION SHEET START FROM HERE · Make sure POWER is COMPLETELY OFF at the fuse box · Have your fixture installed by a qualified licensed electrician · Prepare everything in a clear area · Wear gloves at all times during this installation · Read instructions carefully before you start assembly · Keep this installation sheet for future reference Technical Support: 1-855-855-8926 Please Note: · This Kuzco LED fixture comes with pre-wired LED module(s). · Unless instructed to do so, please do not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage. · For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required. · 120V input 1. Remove the fixture from its original packaging. Remove the mounting plate (1c) from within the canopy backplate (2a) by loosening the four set screws (2d) and two screws (2b). Secure the mounting plate (1c) to the junction box (1a) with screws (1d) provided in the hardware package. 2. Attach the canopy backplate (2a) to the mounting plate (1c), which is attached to the electrical junction box (1a) on the wall. First, make proper electrical connections (black to hot "L", white to neutral "N", ground to "GND") with wire nuts (1b) provided in hardware package and place driver (4a) in canopy (2c). Now direct the canopy backplate (2a) onto the mounting plate (1c) be sure to line up the mounting threaded holes with the screws (2b). Next, place the canopy (2c) onto the canopy backplate (2a) and secure with all four set screws (2d). 3. FOR OUTDOOR OPTION ONLY To prevent moisture from entering the outlet box and causing a short, seal around the top and side perimeter between the fixture and the wall surface with weather resistant caulking (see Illustration 1). The space at bottom should be left un-caulked to prevent moisture build-up. Illustration 1 caulking 1a. 1b. 1c. 1d. 2a. 2b. 4a. 2c. 2d. 19054 28th Avenue Surrey, BC Canada V3Z 6M3 T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196 W: kuzcolighting.com 20210713