Kitty Sill - EZ Mount Scratcher™

Installation Instructions

1. Using glass cleaner, thoroughly clean and dry the window that will accommodate the Kitty Sill - EZ Mount Scratcher™.
2. Clean each suction cup to ensure proper adhesion to window.
3. Holding the platform with the suction cups already attached, gently push one suction cup against the window. [See Figure 1: Diagram showing one suction cup being pressed against a window.]
4. Level the platform and gently push the second suction cup against the window. [See Figure 2: Diagram showing the platform being leveled and the second suction cup being pressed against the window.]
5. With fingers, push remaining air out of suction cups to ensure a proper adhesion.
6. Align each support strap and adhere the suction cups to the window, taking care to keep similar tension on each strap. [See Figure 3: Diagram showing the support straps being aligned and adhered to the window with even tension.]

Caution and Maintenance ⚠️

As with any suction cup, debris, temperature changes, sunshine, and excessive use can weaken the holding power. K&H Manufacturing recommends removing the suction cups at least once per month to clean the window area, clean the suction cups, and then re-install them for optimal strength.

Operating Blinds and Curtains

To operate blinds, curtains, and window coverings with the Kitty Sill attached, simply flip your new Kitty Sill up against the window. Run straps back through the holes in the corners to support the platform in the upright position. Blinds can now operate normally.

Refills

Refill cardboard scratchers can be purchased at participating retailers.