Feelspot Smart Valve Controller Manual

1. Product Profile

Welcome to Feelspot's WIFI smart valve controller. This product offers intelligence, low cost, and high reliability. It can be controlled remotely and utilizes WIFI international technology, ensuring full compatibility with WIFI networks.

Product Image Description: A diagram shows the smart valve controller attached to a pipe. It includes the valve handle, clutch pull ring, and the main controller unit with a support clip.

2. Product Specifications

• Power supply voltage: 12V/1A
• Communication technology: WIFI
• Frequency of communication: 2.4g
• Valve pressure: 1.6 mpa
• Valve specifications: 4, 6, 1 inch, 1.25 inch
• Close valve time: 5-10 seconds
• Open valve time: 5-10 seconds
• Torque: 30-60 kgf.cm
• Application System: IOS/android
• Application Valve type: Handle valve

3. Installation Guide

1. Install the bracket on the installation ear of the smart valve controller (do not tighten the screw first).
2. Fix the mounting bracket on the water pipe or gas pipe as shown in the figure.
3. Adjust the position of the smart valve controller so that its output axis aligns with the axis of the "water/gas pipe" valve handle. Tighten the screws on both ends of the mounting bracket.
4. After installing the smart valve controller, manually pull down the clutch pull ring and swing the transfer handle. Check if the valve switch is in place.
5. Tighten the screw of the smart valve controller handle clip according to the diagram.
6. Connect the power adapter of 12V/1A.

Diagram Description: The diagram illustrates the components involved in the installation: Smart valve handle, Valve handle, Clutch pull ring, valve, stainless steel tie, support clip, smart valve center shaft, and valve center shaft.

4. Guidelines for Use

1. Scan the QR code to download the "Smart Life" APP. Install and apply the APP, then follow the prompts for account registration.
2. Add equipment: Click 'add+', select 'other equipment', and press the power button [power-symbol] on the controller for about 5 seconds until the indicator light flashes quickly. The controller will enter pairing network state. Follow the prompts to input the WIFI password and complete the pairing.
3. The default state after pairing is 'closed'. The controller can be switched as needed. When opened, the indicator light is always on [on-symbol]. When closed, the indicator light is off [off-symbol]. You can manually press the button [switch-button] to switch the valve, or use the mobile phone APP. The product supports functions like timing, sharing, and linkage. Refer to the APP description for details.
4. If the button is pressed again for about 5 seconds after successful pairing, the LED indicator light will flash quickly, deleting the original pairing information and initiating a new pairing process. For multiple mobile devices, use the APP's sharing function to allocate to multiple accounts.
5. In the absence of WIFI, the controller can operate the valve by pressing the button [button-symbol]. When the valve is closed, it opens after pressing the button; when open, it closes after pressing. If the power is cut off, the pull ring under the smart valve controller can be manually pulled down to swing the transfer handle to close or open the valve.

5. Failure Guide

• Valve controller switch is not in place: Check if the smart valve controller axis center and the valve center axis are aligned. Misalignment can prevent proper switching and potentially damage the controller's motor.
• Valve switch is stuck: Pull down the clutch pull ring and swing the smart valve controller's handle 90 degrees until the valve switches smoothly. If the valve is too tight, consider replacing the valve.
• Smart valve controller cannot be paired into the network: Ensure the WIFI signal is strong. Keep the controller close to the router during the pairing process.
• For other troubleshooting issues, consult the APP's help center.