Installation Guide for FDFRaceshop models including: S197, S197 Mantis Angle Kit, Mantis Angle Kit, Angle Kit, Kit
Angle Kits – FDFRaceshop
Ford Mustang S197 Mega Mantis Angle Kit – FDFRaceshop
Installation Guide FORD S197 MANTIS KIT Fully Assembled view of the s197 mantis kit is shown for the left side of the car 1- KNUCKLE ASSEMBLY 2- COMPRESSION ARM MOUNT 3- LOWER CONTROL ARM *Bolt check regularly, take note of the orientation of all the components in this view* *do not exceed the rod ends adjustments, each rod end should have a minimum of 1 to 1.5x the diameter of the joint. (example, a ¾" rod end needs to have approx. 3/4"-1 1/8" inside of the arm at a minimum, this is 12-18 threads) -ACKERMANN PLATES see image for the Ackermann plates. The kit will come with zero Ackermann plates installed and include +2/-2 options that can be changed out. Ackermann is the difference in angle measured at full lock. Example- with 0 ackermann plates installed, the angle of the car will be 60 on the inside wheel, and 60 on the outside. *please note that alignment settings, rack position and other variables can effect the Ackermann curve resulting in differences from chassis to chassis, make adjustments according to your individual setup* DETAIL NOTE- BUMP STOP BOLT AND CALIPER SPACERS- using the bump stop bolt, adjust the length to limit the angle. This is to avoid contact from the wheel to control arms or other components. Install the caliper spacers provided to re-use the factory caliper bolts. Alignment Recommendations Caster 6.5-7.5 + or - .5 Camber -4 + or -1.0 Toe 0-1/8th out Wheel size recommendation 18x9 +10 offset (close to this size will work well) For Racing Use only Not For Must be installed by a licensed Road Use professional fdfraceshopcustomerservice@gmail.com +1(613)243-8859Microsoft Word for Microsoft 365