Owner's Manual for MEAN WELL models including: LPL-18-12, LPL-18-24, LPL-18-36, LPL-18 Series Single Output Switching Power Supply, LPL-18 Series, Single Output Switching Power Supply, Switching Power Supply, Power Supply
File Info : application/pdf, 2 Pages, 493.27KB
DocumentDocument18W Single Output Switching Power Supply LPL-18 series SPECIFICATION LPS IP67 User's Manual (LVD) MODEL LPL-18-12 LPL-18-24 LPL-18-36 OUTPUT INPUT DC VOLTAGE 12V 24V RATED CURRENT 1.5A 0.75A CURRENT RANGE 0 ~ 1.5A 0 ~ 0.75A RATED POWER 18W 18W RIPPLE & NOISE (max.) Note.2 120mVp-p 150mVp-p VOLTAGE TOLERANCE Note.3 ±3.0% LINE REGULATION ±1.0% LOAD REGULATION ±2.0% SETUP, RISE TIME 1500ms, 30ms / 115VAC HOLD UP TIME (Typ.) 20ms/115VAC at full load VOLTAGE RANGE 90 ~ 132VAC 127 ~ 186VDC FREQUENCY RANGE 47 ~ 63Hz EFFICIENCY(Typ.) 80% 83% AC CURRENT INRUSH CURRENT(Typ.) 0.5A/115VAC COLD START 40A(twidth=200s measured at 50% Ipeak) at 115VAC 36V 0.5A 0 ~ 0.5A 18W 200mVp-p 84% MAX. No. of PSUs on 16A CIRCUIT BREAKER LEAKAGE CURRENT 16 units (circuit breaker of type B) / 27 units (circuit breaker of type C) at 115VAC 0.25mA / 115VAC OVERLOAD PROTECTION OVER VOLTAGE Above 105% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 13.8~ 16.2V 27.6~ 32.4V Protection type : Shut off o/p voltage, clamping by zener diode 41.4 ~ 48.6V OVER TEMPERATURE Shut down, recovers automatically after temperature goes down WORKING TEMP. WORKING HUMIDITY -30~ +70 (Refer to "Derating Curve") 20 ~ 90% RH non-condensing ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +80, 10 ~ 95% RH TEMP. COEFFICIENT ±0.03%/ (0 ~ 50) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes SAFETY STANDARDS EAC TP TC 004,IP67 approved; design refer to UL1310 Class 2,TUV EN60950-1, EN61347-2-13, CAN/CSA C22.2 No. 223-M91 SAFETY & WITHSTAND VOLTAGE EMC ISOLATION RESISTANCE EMC EMISSION I/P-O/P:3KVAC I/P-O/P:>100M Ohms / 500VDC / 25/ 70% RH Compliance to EN55022 (CISPR22) Class B, FCC Part 15, EN61000-3-2 Class A, EN61000-3-3, EAC TP TC 020 EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, EAC TP TC 020 MTBF 6901.7K hrs min. Telcordia SR-332 (Bellcore) ; 1171.8Khrs min. MIL-HDBK-217F (25) OTHERS DIMENSION 140*30*22(L*W*H) PACKING 0.175Kg; 70pcs/13.3Kgs/0.71CUFT NOTE 1. All parameters NOT specially mentioned are measured at 115VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf) 5. Suitable for indoor use or outdoor use without direct sunlight exposure. 6. The ambient temperature derating of 3.5/1000m with fanless models and of 5/1000m with fan models for operating altitude higher than 2000m(6500ft). Product Liability DisclaimerFor detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx File Name: LPL-18-SPEC 2024-02-19 18W Single Output Switching Power Supply Mechanical Specification AC/N(Blue) AC/L(Brown) 300±20 UL 1015 18AWG 140 3.6 71 3.5 T case 3.5 3.6 T case: Max. Case Temperature LPL-18 series 300±20 UL 1015 18AWG Unit:mm -V(Black) +V(Red) 3.5 AC IN 13.5 30 DC OUT 3.5 22 Recommend Mounting Direction Block Diagram I/P EMI FILTER RECTIFIERS POWER SWITCHING PWM CONTROL RECTIFIERS & FILTER DETECTION CIRCUIT fosc : 60KHz +V -V Derating Curve Static Characteristics 100 80 60 40 20 -30 0 10 20 30 40 50 60 70 (HORIZONTAL) AMBIENT TEMPERATURE () 100 90 80 70 60 50 40 90 100 110 120 132 INPUT VOLTAGE (VAC) 60Hz File Name: LPL-18-SPEC 2024-02-19 LOAD (%) LOAD (%)