Vevor Leaf Trimmer

Product Overview

Vevor is committed to providing tools at competitive prices. The phrase "Save Half" or "Half Price" represents an estimate of savings compared to major top brands and may not apply to all categories. Please verify savings when placing an order.

This manual provides instructions for the Vevor Leaf Trimmer, Model TM19. It is designed for trimming leaves and buds from plants.

Important Safety Instructions

WARNING: Read all safety warnings, instructions, illustrations, and specifications provided with this product. Failure to follow these instructions may result in product damage or serious injury.

Basic Safety Information:

• This product is for trimming leaves only.
• The blade is very sharp; be careful to avoid injury when using or replacing the blade.
• If the trimmer will not be used for a long time, place the sheath on the blade.
• Ensure the lid is securely on before use.
• Use the trimmer gently. Violent use can cause accidental injury and damage to the trimmer.
• Never place fingers, gloves, or any body part in contact with the grill or the blade.
• Do not use scissors, knives, or any other instrument above the grill.
• This product is not a toy. Do not allow children to play with or near this item.

Please Note:

Vevor does not accept responsibility for damages caused to or by the trimmers resulting from inadequate use or assembly. Use the trimmers in accordance with existing laws and regulations.

SAVE THESE INSTRUCTIONS

Basic Parameters

Operation

1. Remove the top: Lift the transparent dome lid from the trimmer's base. The inside of the lid has high-density rubber tongues designed to push plant leaves into the cutting grill. The cutting blades are located below the grill.

2. Place plants on the grill: Arrange the untrimmed plants on top of the grill. Ensure the grill surface is adequately covered, approximately 40 dry grams of plant material.

3. Replace the top and handle: Securely place the lid and attach the handle back onto the base.

4. Turn the handle: Rotate the handle clockwise for approximately 15-30 full rotations. The internal rubber tongues will multiply the spinning rate of the plants and blades. This action presses and rolls the plants into the spinning blades, enhancing cutting efficiency. A short period of operation can yield significant results.

5. Collect the trimmed plants: Open the lid. The trimmed plants will be on the middle grill, and the cut leaves will be in the trimmer basin. The trimmed leaves can be used for preparing essential oils.

6. Repeat for more harvest: If finer trimming is desired, repeat the operation process until the desired result is achieved. After use, clean all parts of the trimmer and store it properly.

Contact Information

For product questions or technical support, please contact Vevor:

Email: CustomerService@vevor.com

Address: Sanven Technology Ltd., Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730