7-OUTLET SURGE PROTECTOR
Model Numbers: CSB706/CSB706W
Diagram
Diagram of the CyberPower 7-Outlet Surge Protector: The device is a horizontal power strip. Point 1 indicates the [ON/OFF Reset Control Switch and Circuit Breaker]. Point 2 indicates the [Protected LED Indicator] light. Point 3 indicates the seven [Standard Grounded Outlets (7)] arranged along the length of the strip.
Features
- [ON/OFF Reset Control Switch and Circuit Breaker]: Controls power to all outlets. The switch is also a 15 A breaker. When an overload occurs, it will automatically switch off. To resume operation, ensure the overload condition is removed and reset the surge protector by switching the unit ON.
- [Protected LED Indicator]: Illuminated when the surge protection feature is working properly.
- [Standard Grounded Outlets (7)]: Seven grounded outlets for connecting multiple devices.
Specifications
| Specification | Details |
|---|---|
| Model Number | CSB706/CSB706W |
| Outlets | Standard Outlets (7) |
| Power Cord Length | 6 ft |
| Surge Protection | 1800 Joules |
| Electrical Rating | 125 V/15 A/1875 W |
| UL Clamping Voltage | UL 1449 4th/800 V (H-N, H-G, N-G) |
| Maximum Peak Current | 45,000 A |
| 3 AC Lines Protected | H-N: 15,000 A; H-G: 15,000 A; N-G: 15,000 A |
| Response Time | Less than 1 nanosecond |
| Circuit Breaker | Resettable 15 Amp |
Warning
This product can expose you to chemicals including vinyl chloride and bisphenol A (BPA), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Caution
TO REDUCE THE RISK OF ELECTRIC SHOCK:
- Use only in dry locations and only indoors.
- DO NOT plug into another relocatable power tap.
- DO NOT "daisy chain" surge protectors.
- DO NOT use with any aquarium equipment.
- DO NOT use if properly grounded outlets are not available.
- DO NOT install this device if there is less than 10 meters (30 feet) of wire between the electrical outlet and electrical service panel.
- DO NOT use for medical or life support equipment. This device features an internal protection that will disconnect the surge protective component at the end of its useful life, but it will maintain unprotected power to the load.
Troubleshooting
If the [ON/OFF Reset Control Switch and Circuit Breaker] is switched [OFF Switch], the 15 Amp circuit breaker may have tripped. Examine your connected equipment and remove the device that is overloading the circuit. Then, turn the ON/OFF switch back to [RESET Button].
If the [Protected LED Indicator] does not light, the surge protector's AC lines are no longer protected from surge. The surge protector may have received a power surge or spike beyond its specified limits that overloaded the protection circuitry and rendered it inactive. The surge protector has protected your connected equipment as designed, but it will not protect against future surges, and spikes. It should be replaced.
For More Information
Visit CyberPowerSystems.com for more information regarding:
- Product information and certifications
- Product warranty
- Connected equipment guarantee
Technical Support
Visit: CyberPowerSystems.com/support
Toll-Free: 1-877-297-6937








