Tune It Up Waterproof Speaker & Flashlight

Product Overview

The Tune It Up is a versatile waterproof speaker and flashlight designed for portable audio and illumination needs.

Controls & Ports

The speaker features several control buttons and ports for operation:

• Button 1: On/Off / MODE change
• Button 2: Next song / Volume (+) - Long press to increase volume; short press to play the next song.
• Button 3: Previous song / Volume (–) - Long press to decrease volume; short press to play the previous song.
• Button 4: Play/Pause / Hang up - In MP3 mode, press to pause/play the song. For calls, press to answer or hang up. For emergency use, press for First Aid mode.
• Button 5: Flashlight - Press once to turn the flashlight on. Press twice for emergency/First Aid mode.
• Port 6: TF card slot - For playing music from a TF card.
• Port 7: Charging port - For charging the device.

Pairing Device with Phone

1. Power the device on.
2. Go to the Bluetooth settings on your smartphone.
3. Select "Tune it up" from the list of available devices to pair.

Charging Device

Charge the device using the included USB wire attachment or a 5V / 1A power cord.

Troubleshooting

Will not connect:

• Verify Bluetooth is turned on and enabled on your smartphone.
• If too many peripheral wireless devices are searching, close other wireless devices that are not currently in use.

Sound too low or is distorted:

• Increase the volume on your smartphone.

Breaks in the music / output intermittent:

• The device may be too far from the phone, causing a poor connection. Move the devices within 10 yards (approximately 9 meters) of each other.

Product Specifications

• Model: Tune it up
• Output power: 2x3W
• Wireless equipment: Bluetooth 5.0
• Wireless receiver distance: 10M (10 yards)
• Audio power: 3.7V – 1500mA
• Charge output voltage: 5V 500mA or 1A 5V

FCC Information

FCC Warning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution:

Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.

Compliance Statement:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Radiation Exposure:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.