Enbrighten LED Light Fixture

Installation Instructions

IMPORTANT SAFETY INFORMATION: Read all instructions before installation.

1. ELECTRICAL HAZARD: Turn off power at the circuit breaker or fuse box before beginning installation. Failure to do so could result in serious injury or death.
2. WIRING: Ensure all wire connections are secure. Loose connections can cause arcing and fire. If you are unsure about wiring, consult a qualified electrician.
3. GROUNDING: This fixture must be grounded. Ensure proper grounding connections are made.
4. MOUNTING: Mount the fixture securely to a suitable surface.
5. ENVIRONMENT: This fixture is intended for indoor use only. Do not expose to moisture or extreme temperatures.
6. DISCONNECT POWER: Always disconnect power before servicing or cleaning the fixture.

Installation Steps

1. Turn off power: Before beginning installation, turn off the power at the circuit breaker or fuse box.
2. Mounting Bracket: Attach the mounting bracket to the junction box using the provided screws. (See Figure 2)
3. Wire Connections: Connect the wires from the fixture to the corresponding wires in the junction box.
   • Black wire (hot) from fixture to black wire (hot) from power source.
   • White wire (neutral) from fixture to white wire (neutral) from power source.
   • Green or bare copper wire (ground) from fixture to ground wire from power source.
   Use wire nuts to secure connections. (See Figure 3)
4. Secure Fixture: Carefully tuck wires into the junction box. Align the fixture with the mounting bracket and secure it in place. (See Figure 4, 5, 6)
5. Restore Power: Once the fixture is securely mounted and wired, restore power at the circuit breaker or fuse box.
6. Test Fixture: Turn on the light switch to test the fixture.

Diagram Descriptions

Figure 1: Illustrates the cross-section of the LED light fixture, showing the light diffusion.

Figure 2: Shows the mounting bracket being attached to a surface with screws.

Figure 3: Depicts a wire connection using a wire nut to join the fixture's wires to the house wiring.

Figure 4: Shows the fixture mounted and wires tucked into the junction box.

Figure 5: Illustrates the fixture mounted and secured to the mounting bracket.

Figure 6: Similar to Figure 5, showing the final mounted fixture with wiring.

Included Installation Hardware

• Mounting Screws
• Wire Nuts