Installation Guide for Marshall models including: RS7-HR, Control Distribution Box, RS7-HR Control Distribution Box, Distribution Box, Box

RS7-HR Installation Guide

Marshall Electronics CV-PTZ-BND1 Summer Broadcast Production PTZ Camera Essentials Bundle | Full Compass Systems

Marshall Electronics CV-PTZ-BND2 Summer Church Production PTZ Camera Essentials Bundle | Full Compass Systems

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 2 Pages, 721.81KB

Document Document

RS7-HR
Installation Guide

HARDWARE OVERVIEW

1

2

3

4

567

1 Power Indicator 2 Controller Input 3 Connection refresh 4 Output Connection 5 RS232 / RS422 Selector 6 Firmware Service Port 7 DC Power Connection

RS7-HR CONNECTION
The RS7-HR can be set on a desk top or you can use the included 1RU rack ears to install a rack. Please note the following: · Before connecting your equipment please select RS232 or RS422 on the back of the unit · Connect your controller to the Input connection on the front of the RS7-HR using a Cat 5/6 cable · On the back of the RS7-HR connect your Cat 5/6 cables from the RS7-HR to each camera (you
may need optional CV620-CABLE-07 Adapters for RS232) · You will now connect power to the RS7-HR, you will see a red indicator light appear on the front
of the unit, now you will push the refresh button once · If you disconnect a camera or add a camera you will need to push the refresh button again

RS232 / RS422 Pin Instructions

VS-PTC-IP RS7-HR

Cat 6

RS422 RS422 RS422 RS422

RS422 RS422 RS422

RS422

VS-PTC-IP RS7-HR
Cat 6

CV620CABLE-07
RS232

RS232

RS232

RS232

RS232

RS232

CV620CABLE-07
RS232