Grape Solar – Clean Power. Today.
User Guide for GrapeSolar models including: 100 Watt Off-Grid Basic Charging Kit, GS-100-BASIC
Version 210510. ©Copyright 2021, Grape Solar Inc. ... owner's manual and GS-STAR-100W connection guide (both included with products) before ...
owner’s manual and GS-STAR-100W connection guide (both included with products) before assembling kit. For additional information about Grape Solar products: email Support@GrapeSolar.com, or call 1-877-264-1014 for live telephone support. ... 5/12/2021 4:03:38 PM ...
File Info : application/pdf, 2 Pages, 611.98KB
DocumentDocumentGS-100-BASIC PHOTOVOLTAIC POWER GENERATION SYSTEM QUICK CONNECT GUIDE Rev. 210510 100 Watt Off-Grid Basic Charging Kit (GS-100-BASIC) Quick Connect Guide IMPORTANT: Please read GS-PWM-20A charge controller owner's manual and GS-STAR-100W connection guide (both included with products) before assembling kit. For additional information about Grape Solar products: email Support@GrapeSolar.com, or call 1-877-264-1014 for live telephone support. 1 Check your order to make sure that all parts are included: GS-PWM-20A Charge Controller GS- STAR-100W Solar Panel 5-foot Bare to Ring-lug Cable Pair Black 15-foot MC4 Extension Cable Additional tools and equipment you will need: Screwdriver Philips Head 12-Volt Deep-Cycle Battery Bank Wire Stripper/Cutter Voltmeter (for Troubleshooting) [diagrams not to scale] 2 Mount the 100-watt solar panel so that it is facing due South at approximately the same angle as your latitude. The ideal area has full sun and no shading. If the following connections are made during daylight, cover the panel with cardboard, cloth, or a similar opaque material so that the panel does not output power. 3 Connect the wire end of the red battery cable to the "+BATTERY" terminal on the back of the GS-PWM-20A charge controller . Connect the wire end of the 5-foot black cable to the "-BATTERY" terminal. A Phillips head screwdriver can be used to loosen and tighten the screw clamps onto the wires. Attach the ring lug end of the red cable to the positive terminal of a 12V deep cycle battery. Attach the ring lug end of the black cable to the negative terminal. *12V deep cycle battery not included with kit www.GrapeSolar.com Tel. 1-877-264-1014 (toll free), 1-541-349-9000 Document Version 210510 ©Copyright 2021, Grape Solar Inc. GS-100-BASIC PHOTOVOLTAIC POWER GENERATION SYSTEM QUICK CONNECT GUIDE Rev. 210510 4 Using wire cutters, snip the 10-gauge, 15ft. MC4 extension cable into two equal halves (7.5ft each.) On the cut ends, strip off ¼-inch of insulation, revealing bare wire. 5 Connect the MC4 ends of the halved cable to the compatible MC4 ends of the solar panel cables. (Mark the end of the positive panel cable with a piece of tape to help distinguish polarity during connection.) 6 Connect the bare wire end of the positive cable to the "SOLAR +" input of the charge controller . Connect the negative bare end to the "SOLAR -" input. Now, you can mount the GS-PWM-20A charge controller to an indoor wall or within a NEMA-3R rated enclosure. *12V load not included 7 Remove the panel covering. In good sunlight, the charge controller's "BAT %" should increase to 100%. Once the battery is fully charged and the controller is set to "LOAD ON," the system will provide power through the load control output or through the two USB ports. If an inverter is added to the system, it must be connected to the battery bank, and not to the charge controller. DISCLAIMER: Installations of this kit could be subject to national and local building and electrical codes. Installers should have adequate knowledge of national and local code to ensure the installation passes inspection by the local electric authority. Proper fuses or breakers should be used whenever possible. Contact Grape Solar for specific recommendations. All batteries used for this system should be identical. Do not mix battery types or sizes. Do not mix old batteries with new batteries. Performance and charging anomalies can occur if types, sizes, or age of batteries are not identical. Grape Solar does not warrant the accuracy, sufficiency, or suitability to all customers of any technical or other information provided in product manuals. Grape Solar does not claim any responsibility or liability for losses, damages, costs or other expenses whether special, indirect, consequential or incidental, which might arise out of the use of such information. www.GrapeSolar.com Tel. 1-877-264-1014 (toll free), 1-541-349-9000 Document Version 210510 ©Copyright 2021, Grape Solar Inc.